Improve your trunk base | Bonsai technique | English Elm triple trunk

Bonsai Ideas
277 followers
5 Video ViewsยทNov 15, 2024
Too late now. In this video I'm going to show you a technique that's used by a lot of bonsai
artists to make the trunk base look a lot better. Enjoy the video. If you want to make the trunk
base on your bonsai flare out like an old mature tree, one common technique to achieve this is a
ground layer. Stay tuned and I'll show you how to do it. First let's go back to the origin of this
which I rescued from a hedge looking bedraggled and unruly. But enough about me, this is how the
tree looked. I found it stuck between some iron railings so I decided to take an air layer. Now
this is the reason for today's video because I made the layer too far down the trunk leaving
some bad inverse taper, the exact opposite of what we're trying to achieve here. So I kept the air
layer there through spring of that year and by the end of May it produced a handsome amount of roots.
So in June I chopped it off, sorted out the new roots and put it in a training pot for a couple
of years. Then in January 2021 it was clear that the tree needed a whole new trunk base just
underneath a three-way split. And now let's zoom forward to May 2021. So I'm going to air layer it
in a way that some people call ground layering because we're actually just going to build up
the soil around it but I am going to use the normal practices of air layering. So a straight
line cut just around the trunk where I want the new roots to emerge. So let's head over to the
whiteboard and take a look at how a ground layer works. This squiggle is a rather simplistic
representation of my triple trunk helm and let's at least give the poor thing a few branches and
leaves. And we'll chuck it in a pot with some soil. Now when you see it like this we're not
looking at a triple trunk but a three-way branch split with terrible inverse taper. So the goal of
a ground layer is to make a new trunk base and root collar at exactly the place you want it and
in this case I want to make it so that the three trunks come right out of the trunk base and we can
go one step further. We can actually use this technique to set the trunk base and new root
plane at a different angle if needed. You literally determine the line where the new roots are going to
emerge. So let's take a close look at the physiology of the tree trunk and see how we achieve this.
Now inside the bark is a layer of live tissue called phloem which transports the photosynthesized
sugars down from the leaves and it also transports the growth hormone auxin which activates root
growth. Can you see where this is heading? Now inside the phloem is the vascular cambium and the
cambium is what creates all the other plant tissue in the stem including callusing. Now inside the
cambium we have the xylem which transports up water and nutrients from the roots and inside
the xylem we have the heartwood which is basically dead xylem but much harder. So armed with this
knowledge we can now make a cut into the trunk all the way around at the line that we want the
new trunk base to be and we also cut in another line so we are girdling the whole trunk just here
and to do that we remove all the bark, the phloem, the cambium and the xylem. Wait a minute you don't
have to remove all the xylem but I found you can and the air layer or ground layer works just as well.
So now we go ahead and strip off these layers all the way around this level of the trunk
and you can leave some sapwood but just make sure there's no cambium left on it because that would
callus over and could jeopardize your layer. And now some recommendations to really make sure you
get roots there. Paste the whole area with rooting hormone gel or powder and then plaster it with
damp sphagnum moss and a good tip mix in some akadama with the chopped sphaggy that'll make
much easier to unravel the roots at the end of all this process. Then you can cover the whole
area with a cylinder of drainage mesh or just a sheet of plastic would suffice then let it grow
for the rest of the season then either in autumn if you're brave or the following spring to be safe.
Unravel the new roots and chop off the old trunk. Quick caution just make sure there are enough
roots before you remove the layer you can always leave it there another year. Now you can repot it
the right angle. Admire your new trunk base and watch as that circle of new roots gradually turns
into lovely nibari. Just get my famous pen out and draw a line around where I envisage the roots
should come out. This is where I'm going to cut around the back so I'll get my very sharp knife
I'm pressing in very hard so I go right through the bark and the cambium.
Now make another cut down here above the roots. Cut at the top and the bottom now I'm going to
make a cut from one to the other and then start peeling the bark away and we'll see how deep it's
gone. Right so the next job I'm going to make sure that none of the sap can come up here so I'm going
to use a tourniquet. Now I've got rooting hormone which I'm just going to spread around here
Right so now I'm just going to put some sphagnum moss right on there before I put the new pot on
so ideally you want this to be nice and chopped and now I'll put the new pot on. A pot that's going
to hold all the rest of the soil in place. Now I'm going to sellotape that together.
Put a bit more akadama in there. Now this soil on top is just akadama mixed with organic substrate
about 50-50 and the idea of this soil here is actually to try and keep it wet and cool
in July and August. That's my work done for now.
So now it's mid-September the ground layer has done its job and now it's time to remove the
casing but at this time of year in early autumn we want to avoid damaging any of the roots
so then the new roots will carry on growing into the rest of the soil over the remainder of autumn.
Just pull that off. So now we have to gently dismantle that lovely layer cake trying to
ease out the roots and head them outwards radially and if you use a drainage mesh instead of a plastic
case then you don't get these windy round roots but the disadvantage is that the mesh itself
can be harder to take off if the roots have grown through it and then we cover them up with soil
The first sign of new buds in spring I'll take all this soil away, unpot it and we'll inspect
the root ball then. I'm just going to put this little rock under that side of the pot
and now I think the angle is a bit better. Now when you see it like that
I kind of think this is too long so here we go. Done. Too late now.
And if you're unsure about branch pruning decisions I have a whole playlist with pruning
tutorials linked in the description below. So here we are at the end of March 2022 and it's time to
repot this triple trunk elm and just leave the roots from the ground layer. Very good soil here
Yes see under here is quite pot bound, quite a lot of cutting here. None of these roots
would be useful. You can see the nice new roots coming down here and these ones here
are the old roots sticking up so I need to remove those. The thing about ground layering is you make
ready-made nevari. Fantastic. And now I can saw all of that off and have a nice flat root plane.
Here it is our new trunk base and now what we want to do here is achieve a completely flat
bottom of the trunk so that it can fit into a shallow pot. So now we just need to shorten some
of these big long ones. Base layer of soil I'm putting mostly pumice and now I'm going to do the
rock trick again. Now mounding the soil over my rock see how it goes like this and some of these roots
are still just too long and that will be the front for this year. A little bit more soil in there
and for the top dressing I'm going to put this mix of fine grain akadama and fine grain kiriazune
for the purpose of keeping on wicking up the water and now we'll give it a good watering.
If you would like to see the 95-minute feature film of this work in a relaxing video that shows
all the details and decisions along the way I've added the link to the film on Patreon in the
description below this video or if you want to see another short Blue Sky Bonsai video
just click on one of these videos here.
