AK "Alpha Trainer" to 500 yds: Practical Accuracy [EO Tech EXPS 2-2 failure point]

Sunday Enjoy
2 followers
6 Video Views·Nov 11, 2024
This episode was brought to you by Slate Black Industries. For M-LOK grips and accessories,
visit slateblackindustries.com. Now, we've taken numerous Kalashnikovs out on this show before,
and most of them have actually performed quite well. The same goes for short-barreled ARs or
AR pistols. Now, that might not necessarily be the case today. It's all dependent upon your
perspective, really. But we want to certainly suggest that you stick around for the debrief
portion of this particular Practical Accuracy Run, because we are going to overlay some
additional shooting and commentary specific to what you're about to see. We'll see you
Impact. Good impact. Neutralized. We are on at 200.
Impact. Oh, malfunction. Yikes. Anytime there's a malfunction, there's obviously a lot of questions
and commentary in the comment section of the video. What I want you to understand is that
this particular instance, we were testing and evaluating the longevity of this particular
firearm without cleaning. We were probably about 2,200 to 2,500 rounds in of suppressed 5.56
through this setup without cleaning it. As you might imagine, the hammer face, the bottom of
the carrier group, the chamber, it's all caked with carbon. We wanted to see how long we could
push this as part of collecting data for you guys for the long-term classic review, which will
ultimately be coming for this particular firearm. What you're seeing here is the starts of some of
the failure points. We are pushing the particular setup well beyond what we would normally do,
where we would take care of or otherwise maintain our firearms, to see what would happen. That's
what you're seeing here. All right, back to the run.
I haven't seen that thing malfunction. No, that's the first time. What happened to you, I think?
Uh, I don't know. We'll find out, see if it does anything else. I mean, I haven't cleaned it.
You're also shooting it suppressed.
Impact. That's neutralized. All right, go ahead, proceed. Let's see, let's proceed to 250, stand by.
Left side. Elevation is on the top one-thirds.
Impact. Left edge. Elevation's good.
Impact. Elevation's good. You are on at 300.
Impact. Neutralized. All right, go ahead, proceed to 350, stand by.
Target and a half to the left on the elevation of the bar.
Right side. Elevation's good. You're about half target to the right.
Uh, at the leg of the target.
That's an impact.
That's an impact. So, that's a neutralized shot. Yep. You ready to progress towards four? We are.
Fire when ready.
Good impact. Good impact. Neutralized.
When are you changing to the second dot right now? I, that was a direct bracket in between the two.
Okay. All right. We are on at 450. Fire when ready.
Uh, left edge. Elevation's just slightly low on the lower one-third, but you're on the left edge.
Right edge. Almost the exact opposite. Elevation's the same on the lower one-third.
That's a good impact. Square on.
That's 20 down. Okay. Yeah, I'm definitely, I'm really struggling being able to try to find out
where the target is in relation to that second dot. Uh-huh. Because it's, the target's obviously
quite small at this distance. Yeah. It's all kind of bleeding together on me.
Right side. On the edge. At the very low edge of the target as well.
Right edge. Elevation is better.
Uh, that was on the top left. Half a target high on the left edge.
That was on the right. Let's see. Half target right,
where the strap is on elevation. Is your suppressor on tight? Yeah. Okay.
Uh, bottom left.
Right side. Same elevation. Half target.
Okay. Elevation's good, but you're still half a target to the right.
Left side. Strap length. One target left. That's an impact. All right. So it's definitely,
it's not a facet of the gun. It's, I think it's a limitation of my eyes and how I'm perceiving the
sight. Okay. Because the advantage of the double dot EOTech is that you have a very, you know,
the EXPS-2 as opposed to dash zero, is you have quite a bit of advantage insofar as you have the
BDC, you know, or a form of BDC. The problem is, at least for me and my eye, the EOTech is already
kind of pixelated. And so I'm seeing like the pixelation up top, the pixelation down the middle,
and the target is like in behind all the pixelation. It seems to be quite difficult to
aim. You know that, that I do think there is a disadvantage to the holographic sights versus
the diode sights. Yeah. Because the diode sights are so much more crisper. Right. I.e. the
aim point is holosized. Yeah, like even though this is, even though this is only a 1 MOA dot,
right? Right. It still feels like it's, it's because of the low resolution. Right. Perhaps
a magnifier would help with that? Yeah. I mean, unfortunately with this type of rail setup,
there's really not any space for the magnifier. I could, I could potentially jam this forward and
fit a magnifier there, I guess. But yes, agreed. So let's try to finish it out at five. I'm on at
five. All right. No observation. Left side, nine o'clock, one target length to the left.
That is your 10, 11 o'clock position. Bottom right at your four o'clock position. Elevation
is at the base, right underneath the target. Top right. Because that, that was a solid second dot
hold. So I'm going to try to just favor lower portion of the plate with that second dot. Okay.
Nine o'clock, half target to the left.
Nine o'clock, off to the left.
Do you think there's a possibility that it's actually landing on, but not moving it? I don't
know. That's it. I don't see it moving though. That's a thing. That's it. I'm, I'm out. That's my
40. The most important thing here, the most obvious thing I think was my inability to effectively
utilize this particular sighting system. So we were shooting an EXPS2, which means there are
actually two dots within the donut of this particular reticle. I was having a lot of
difficulty perceiving where the target was in relation to these points within the reticle.
Now, again, we're not shooting at humanoid size targets, which is what this reticle style was
designed for. Instead, we're shooting at sub-torso, sub-C zone even, size targets, especially the
450 yard target is, is like that. It's actually smaller than a C zone. So I was having trouble
seeing exactly where that target was between the upper and lower dots, because for that particular
hold, I was sort of having to hold with the target bracketed between them and then holding for wind
off to the side. And as some of you may be familiar, the EOTech reticle has pixelation in it
as you're looking through it. And so with the environmentals of the day, a midday shoot with the
sun nice and high, very hot sweat, trying to perceive where those particular dots were in
relation to the target, I found very, very difficult. I found myself having to actually
pull the reticle off target, refocus on the target, and then bring the reticle back in hopes
of being able to more appropriately understand exactly where the reticle was in relation to the
target. So not an optimal sighting selection choice for this particular implementation, although
we've shot red dots, iron sights, et cetera, out to 500 plus on the show before. So again,
maybe this comes down to a purely shooter error component where I just need some more practice on
that particular reticle, or maybe a different red dot or something like the primary arms two times
or the Cyclops would be more effective, a prism style optic with gradiated lines and reference
points for aiming. Secondarily, let's talk about ammunition selection. We're shooting 55 grain ball.
It's not optimal for securing hits at distance. We understand that. However, we've shot it on
various other platforms and through various other platforms on other runs and secured hits,
including a 10 and a half inch AR pistol. So to suggest that that particular component
was the determining factor would be disingenuous, although an easy out because of course we weren't
shooting around super effective at those ranges. That also partly comes back to barrel twist. This
is a one in nine twist barrel. So shooting a big heavy pill like a 77 or the Mark 262 round just
isn't necessarily possible. The barrel simply can't stabilize it. Unlike the AR pistol,
the Gordon Carbine, this AK prints probably about double the group size of those particular
firearms. So we're seeing groups in the three and a half to four and a half inch range. Now,
that's not all too awful for a Kalashnikov. It's probably on the wider side. Again, we're
shooting nine shot groups in accordance with how we generally test the accuracy of these firearms.
So wasn't optimal, wasn't great. And when we get out to those further distances beyond 400 yards,
which is really where we started to see a pretty dramatic drop off in the capability of this
particular platform, on the size targets we're shooting, a four MOA gun is in some instances
simply going to have a cone of deviation that causes some rounds, not all of them, but some
rounds to miss the target even if the hold was a good hold to secure an impact. With all that said,
we believe that those are some of the contributing factors that led to, well, sort of an underwhelming
performance beyond 400 yards. With that said, we knew we could get some hits at 500. So we went back
out to another 500 yard range out at the ranch here in Eagle Lake, Texas, and we took some shots to
see what we would be able to achieve just sitting down fresh at 500 yards. The results were
not too dissimilar. In fact, they reinforced what we had seen during the practical accuracy run.
We were able to achieve repeatable hits at 500. Yes, we did secure some hits. Yes, more than enough
to clear on our standard practical accuracy course, but after shooting 10 to 20 rounds
and only securing maybe five or so hits, it was obvious that this was a failure point for this
particular system, and in many cases harkens back to the question we posed just a minute ago.
What is this particular system designed to do, and is this really detrimental that we feel
that it isn't effective at the 500, 450, 500 yard lines? Well, again, that really comes down to
We hope you guys enjoyed this video. Until the next time, we'll see you on the ranch.
Do you enjoy arguing with other viewers on the internet on which rifle performs better on
practical accuracy? Well, we have a solution for you. Go to our Patreon page and scroll down.
You'll find the practical accuracy scoreboard where we have ranked and compiled all the data
of all the firearms we have tested on the practical accuracy course. Furthermore,
it's already separated into the different categories, so you can go back to your argument
as quickly as possible, and whether you decide to support us via Patreon,
subscription, or just a normal viewer, we thank you.
It's been like two, one victor, two facts, recon one, over.
