Mixed Signal Circuit Design|| Switched Capacitor Circuits
Oct 6, 2023
Module 6
Good morning all. Today we are going to learn about Switched Capacitor Circuits.
In the past, analog signal processing was used for continuous time circuits.
For example, we were using continuous time circuits with resistor, capacitor and op-amp for analog signal processing.
Now it is CMOS technology.
When it comes to CMOS technology, the tolerance of resistor and capacitor is not as good as in CMOS technology.
To use for analog signal processing function.
Instead of using resistors, we are using MOSFET switches, capacitor and op-amp.
This circuit is called Switched Capacitor Circuits.
The main advantage of Switched Capacitor Circuits is its high accuracy.
Accuracy is proportional to the accuracy of capacitor ratio.
Let's see the advantages and disadvantages of Switched Capacitor Circuits.
1. Compatibility with CMOS technology.
2. Good accuracy of time constant.
3. Good voltage linearity.
4. Good temperature characteristics.
Disadvantages of Switched Capacitor Circuits.
1. Compatibility with CMOS technology.
2. Good accuracy of time constant.
3. Good voltage linearity.
4. Good temperature characteristics.
These are the advantages of Switched Capacitor Circuits.
Disadvantages of Switched Capacitor Circuits.
1. Clock feed through.
2. Overlapping clock.
3. Necessity of bandwidth of signal being less than the clock frequency.
4. Switched Capacitor Circuits are continuous in amplitude and discrete in time.
They are often called Analog Sampled Data Circuits.
Analog Sampled Data Circuits.
Switched Capacitor Circuits.
Switched Capacitor Resistor.
Equivalent circuit.
Switched Capacitor Circuit.
Switched Capacitor Resistor is useful in simulating a charge value resistor generally greater than 1 MΩ.
Switched Capacitor Resistor.
5. Overlapping clock.
5. Non-overlapping clock.
5. Overlapping clock.
5. Non-overlapping clock.
5. Switched Capacitor Resistor.
5. Non-overlapping clock.
5. Switched Capacitor Resistor.
6. V1 and V2 are slow.
The signals V1 and V2 should be band limited to frequency and at least 10 times less than f-clock.

