DIY: Easy and Cheap Leaky Irrigation Valve Repair

TightWadDIY
899 followers
1 Video View·May 25, 2017
You should check your irrigation system the first couple of times you run it each year to make sure you don't have any leaks. Make sure you check your cut off valves for leaks. These slow leaks can end up costing you lots of money if they go undiscovered. The repair is usually less than a dollar.
Welcome back guys it's the Tightwad. Each season when it's time to start using your irrigation
system you need to check it the first couple of times you run this system. You need to open each
of the valves and make sure they're not flooded. You see this one's full of water. That lets me
know that we have a problem. This is a handle that screws into a valve that lets water through
when this zone is supposed to turn on and closes back down when it's supposed to turn off. You'll
notice there are electrical wires in here that send a charge to open the valve and shut the valve.
This one is obviously leaking. This top piece screws down into the valve and there's an o-ring
on the bottom of this that sometimes gets broken or just kinked and we need to replace that o-ring.
So we're going to simply unscrew this righty tighty lefty loosey so we'll be spinning it
counterclockwise to the left and once we pull it off you'll see that on the bottom you'll see an
o-ring similar to this one. If the o-ring is totally missing just put a new one on and it
goes in the top groove above the threads. There are also times when the o-ring is still in place
but it's stretched out or loose and needs to be replaced as well. So let's get started.
So I unscrewed this and if you look closely you'll see on the very top here there's a
rubber washer. It's called an o-ring. You can buy them at most hardware stores and they usually come
either in individual packages like this or they might just be loose in a bin. So first you have
to find out what size you want. I have two sizes here and we'll pull the old o-ring off. It's
already cracked I can tell and we'll just slip the new one right back on and I'll show you how
to reinstall this once we're done. To install the new o-ring you simply put it on here and roll it
down the threads until you get to the groove where it belongs. So the o-ring is rolled just above the
threads and it sits in a groove right here. The next thing I like to do is to take a water hose
and rinse off the bottom threads so that I don't contaminate my irrigation system. I'm also going
to clean out the hole where it goes, you can see down there in the bottom, so that I don't have
any contaminants going through the lines and getting in my sprinkler heads and clogging them
up. Now this just screws back on righty tighty lefty loosey. It is normal threads. You can see
that the o-ring that was in my system was kinked in this corner and it was also really stretched
out and loose. So that's where our leak was coming from hopefully. We've replaced the o-ring
and the last thing we need to do is screw everything back down and turn on our irrigation
system to see if the water level rises. I'll also check this after a day and turn the irrigation
on again to see if any water at all is leaking. Small leaks like this can end up costing you a
lot of money. I hope you found this video helpful. If you did, give it a thumbs up and subscribe to
my channel. Click any of the links on the screen to see more videos that I've recorded
showing home repairs and things I've done around the lawn. I hope you guys have a great day.
