How to change the locks on your RV | Change your CH751 Locks | DIY | RV Security Upgrades

Cherish the Journey
37 followers
Many RV's have the same key when it comes to the storage locks this video shows you how to change the CH751 key lock to the barrel key locks!
How to change the locks on your RV | Change your CH751 Locks | DIY | RV Security Upgrades | Barrel Lock Install.
#howtorv #howtochangervlocks #rvsecurity #rving
Hey guys, welcome.
Today I am going to show you how to change out your baggage locks from the 751 key, the
standard on pretty much all trailers that I know of, and we're going to change it to
the cylinder locks.
So I'm going to show you real easy.
Basically all you need is vise grips, pliers, and a screwdriver.
It could be phillips or flathead.
This one I know I can get with a flathead because it has that slot in there so either
one works.
So let's get to it.
Screw on mine, screw comes off, the latch comes off, real easy.
Next you got a nut here, sometimes you can get it with your fingers.
Other times you're going to need pliers.
Get it a little loose and get it with your hands.
So the nut comes off, mine has a little plastic washer so now we can come down and with your
push it up from the bottom, it has this little clip here to help you open it up.
I don't care to put it back on so I'm going to leave it off on mine.
Next, get all our goodies, you got your keys.
I ordered two packs so the keys are alike on mine so you can do the other side and same
thing, do the same exact thing as you're doing over here.
So let's go ahead, put the cylinder lock on, it just goes in, put our washer back on there
and this will go on there.
Sometimes if you turn it backwards it helps get it threaded, sometimes they're a pain
Just make sure it's good and snug.
So now we've got the new latch, you can probably use the old latch if you wanted to, if you
need to, so put mine on, make sure you put it the same orientation and then instead we
got a nut here so we'll just kind of get that started by hand.
This one's a threaded nut so it actually has a little plastic insert so it's a locking
nut is what they call it, so again just a couple turns.
That one you just want snug enough because that, this latch actually turns so you don't
want it too tight because if you have it too tight you're going to have a tough time locking
the lock.
So then, if I don't throw the key, test it out, and it's a perfect match.
So sometimes you want to test it out before, this one actually doesn't want to quite lock
Might need to use this other one because it has this little angle that makes this bump
out a little bit so I'll probably change that out and put that one on there so that way
it locks nicely just like that one.
So guys, hope you enjoyed this video, give it a thumbs up if you got any advice, if you
learned something new, give me a comment down below, tell me how I did, what you liked about
it, if you want to see more stuff like this or anything else you want questions on or
how to's, give me a suggestion on what we should do next.
But also be looking out for our next video because we're going to be going to the Tonto
Natural Bridge and our favorite brewery that's right around the corner from there as well.
So be looking for that video next week and we'll see you on the next one.
