How To - Replace Tail Lights on an - Audi A3/S3 8P

MotoAdventuresYT
21 followers
4 Video Views·Dec 4, 2022
I hope this helped you replace or change a bulb in your own Audi, there are loads more videos to come on this car. If you want to stick around and find out more make sure to subscribe at - https://www.youtube.com/channel/UC37q8BO_nT18vvoPK88vxjw?view_as=subscriber
I'm going to be showing you how to change the taillight in the Audi A3 or F3 HP versions
on the 2008-2012 versions.
So let's get started.
Okay, so first things first, all you're going to need is one flathead screwdriver.
That's all you're going to need for this job.
And as you can see from the back of your panel here, in your boot,
there'll be a little plastic tab that's up here.
With your flathead screwdriver, you're just going to pry it out.
Which, they can just fly off like that.
But they're just little plastic caps.
Okay, now once you've done that, you want to get your flathead screwdriver
and get on just the little screw that's inside there.
And just take that out.
I've already loosened mine, so there we go.
So as you can see, there's a little hole at the top for your flathead screwdriver to go in.
But it is also a good size for a 10mm socket as well, or spanner.
Well, here's my little spanner.
Okay.
And then, particularly on the front,
from here, you want to just grab the rear taillight gently.
And you want to aim, because there's going to be two clips, well grommets here,
which hold the light in place in the back here.
So you want to try and pull them out as well as the rest of the rear light.
Like so.
Grab that gently.
And there we go.
Now what you'll also see is these two holes will have little rubber grommets that normally sit in here.
But unfortunately, mine went through and now are inside the actual car.
And basically, when these go in, there'll be little rubber sort of selector bits that usually go around here
that stop it from rattling around.
But unfortunately, like I said, I don't have mine anymore.
But if you were to change the bulb, it's just simply four little clips here.
So you just pull these back as well as pulling the rear light cluster up.
But you want to make sure you don't scratch the light as these are very easily scratched.
There we go.
One more.
There we go.
And that's it.
Just lift up like so.
And there's your bulbs.
Let's put it back in.
You want to make sure all the bulbs are secure when you're rusting on the circuits.
Gently relax, getting in your bulbs.
Put it back into the chair light.
And push so you can get all the clips clipping properly.
And don't be afraid just to give it a bit more.
Like so.
As there is a seal in these and they do need to be compressed to seal correctly.
That's it.
When you put the headlight back in, it's basically the same thing but in reverse.
Then make sure you put the wire out of the way.
Gently push.
And just tap it.
Until it falls into place like so.
And obviously from this point, you just want to push the rear taillight in correctly.
And try and screw your plastic bolt back in there.
It's worth pushing the taillight in.
Get your flat head screwdriver on there as well.
And also push as well.
Just so it goes in correctly and doesn't leave any gaps on the other side.
Now you can replace a bulb or replace your taillights in an Audi A3 or S3.
