Fogong Si Octagonal corner bracket Part 2

Traditional architecture of countries
159 followers
14 Video Views·Sep 27, 2022
Source: Richard Wiborg/ Traditional Chinese Architecture
So a bracket set looks pretty complicated.
There's a lot of pieces.
I've made some bracket sets with over a hundred pieces.
There's a language of brackets and once you learn the language
it becomes more understandable and there's standardization
and modules.
So there's actually only a couple of sizes of material used
in the bracket set.
The width and the height of a bracket arm is one standard
module.
The width and the height of this purlin and the hip is a second
standard module and the width and the height of the bearing
blocks is a third standard module.
So in the beginning you order, you know, 10,000 board feet
of this size and 5,000 board feet of that size and you have
big stacks of your standardized material and first, second
and third tier are all the same dimension and all the bearing
blocks are all the same width and height with just some variation
in the length.
One other point about organization and how to create this
building that's 51 meters tall and has 30,000 different parts
is you have a master who designs the overall building and
you have submasters.
So you would have a master of brackets, for example, and he
would probably be part of a lineage in a family that knew
how to do all this stuff, understood the language, had models
and could carry out the design.
Then from the bracket master, you'd have maybe four assistants
who understood what needed to be done and then you'd have 200
carpenters and they would be given wooden templates to mark
out the wood and cut it and the submasters would oversee to
make sure that the joinery was appropriate.
These buildings were built relatively quickly with huge amounts
of manpower and sometimes woman power.
It's quite astounding the amount of organization and planning
that goes into it.
But as I mentioned, there's a language and once you know the
language, you can make things happen.
There's a way to make it simple and sort of to understand the
language of how this is built and that's to have a plan.
So a plan, quite literally, is a view of the structure looking
from the top down on a flat ground plane.
So this is a plan that I drew full-scale of the components
and the crossings.
So this would be a bracket arm here and this would be a bracket
arm here crossing and I could always check my angles and
measurements and where it was really helpful was in laying
out the hip because I could pick off points off the drawing.
Now, of course, you can do this all with a calculator and math,
but to me, this sort of attraction and the magic and beauty
of geometry is that by drawing the lines, you have the exact
measurement you need and you don't even need to know what
number it is.
You don't need to know it to one or ten decimal places.
You just need to know from the drawing that's exactly the
measurement you need.
Indeed, up until fairly recently, that's how builders built
buildings. The English cathedrals, the Chinese temples, things
were drawn and planned and from that the components and the
layout could be determined.
