Whiskey Flights Made From Real Bourbon Barrel Staves

Keimpiece Carpentry
23 followers
3 Video Views·Jan 20, 2023
So the first thing I'm doing here is I'm sorting which staves I actually want to
use and then I'm just marking center on them. They came three feet long
but the client wanted them 18 inches so I'm marking center
and then measuring out. At first I thought the miter saw would be the
easiest way to cut these to length but I soon realized that was a terrible idea
as once you start cutting through it pinches the blade.
I then moved on to just marking a straight edge and using the jigsaw which
worked out famously.
I was racking my brain about the most efficient way to clean these things off.
I settled on just taking them outside and hitting them with the power washer.
That actually worked out really well. You can see here the difference. The
charcoal on the inside doesn't leave any residue on your hands anymore.
You can see here I'm utilizing an ancient Japanese technique
and manufacturing my own precision measuring device template.
There's a slight wobble in each one of these. The easiest way to get rid of it
is just marking where your high points are then taking it over to a belt sander
and knocking them down. You can see here I had to build a
flat jig to go on top of my drill press. This is very important because
as you're moving this piece and drilling all the holes it needs to be level
throughout the process so that your glasses stand vertically.
I'm adding a 45 degree chamfer around all the top edges
and then I'm going to sand it working my way up from 120
to 150 to 220. Using a dark walnut danish oil this stuff goes on pretty
easy and looks really good on oak. Typically on these whiskey flights you
see the metal pieces that are bolted on the ends.
These are the metal bands that are left over from the actual whiskey barrel.
I didn't have those in the ones I ordered so instead I plan on using
thin pieces of walnut. After cutting my first piece of walnut I realized that
the grain direction didn't easily facilitate a bend so I
went back and cut some more pieces with the grain
in the opposite direction. You can see how flexible these are and they lay
really nice on the curved barrel staves.
Here I'm relying on the wood glue to be the primary holding agent
and then using some CA glue and activator just to hold the ends down
until the wood glue actually sets. Here they are with a clear lacquer finish.
The last step is going to be pre-drilling some small holes and then
just hammering in these decorative nails. This project was a lot of fun and I
really enjoyed using these whiskey staves.
If you guys want to do this yourselves I'll have the link on where I got these
staves in the description below. The ones that I used in this project were
three feet long and they were the three inch wide ones.
