Wie näht man ein Turnbeutel selbst? Und wo kann man ein Schnittmuster dazu kostenlos downloaden? Wir zeigen es dir in dieser Anleitung. Gerne kannst du den Schnitt auch für kommerzielle Zwecke verwenden. Wir wünschen viel Erfolg beim Nähen des Turnbeutels und viel Freude damit.
Wir werden oft gefragt, warum wir unser Wissen kostenlos teilen. Als eine der ältesten Schneidereien der Welt haben wir Generationen von Wissen, Übung und Erfahrung gesammelt. Als preisgekrönter Lehrbetrieb werden seit 10 Generationen Lehrlinge und Meister bei uns ausgebildet und Designer weitergebildet.
Leider gibt es immer weniger Ausbildungsbetriebe, um das Schneiderhandwerk von der Pike auf zu erlernen. Und auch wir können in unserem Betrieb jährlich nur 1-2 neue Lehrlinge aufnehmen und ausbilden.
„Leider merken wir diesen Trend immer stärker. Es freut mich natürlich, dass sich so viele Menschen für dieses schöne Handwerk interessieren. Aber gleichzeitig tut es mir weh, jährlich duzende, qualifizierte Bewerber abzulehnen, die unser schönes Handwerk erlernen wollen.“ - Stefan Wimmer
Deswegen teilen wir unser qualifiziertes Wissen und Know-How mit praktischen Übungen und Anleitungen in der Schneider Akademie. Jeder und jede, die gerne Textile Kunstwerke erschaffen möchte, soll die Möglichkeit bekommen, von den besten und erfahrensten Schneidern zu lernen.
Today we are going to sew a fashion bag with a cord,
with an inner pocket,
so really professional, practical, durable,
it should be your favorite piece.
For this we need a cord,
twice in the length of 1.5 meters,
and at the end, if you always put a tape over it,
so that it does not fray.
Then we need two different fabrics
and a fabric for the inside, as a feed fabric.
It can be a light cotton or, of course,
something more stable or water-repellent.
Then you print these cuts in A4,
normally with a printer.
You can download this by PDF
and always glue it together on the different parts.
We have marked this with X,
you glue it together and cut it out.
The parts are described separately,
so that there is no confusion.
The cord is up here,
the outer bag below is this part,
the inner bag comes inside.
Then this is a small pocket for the inside,
which is also glued together here
and cut out again here.
This is the outer bag at the top,
the blue part here.
It is also important,
if you want the bag to be a little bigger,
the turntable bag,
then it is not difficult to change the mass.
It can get bigger, higher, wider,
that is up to everyone.
Cut the parts,
and I wish you a lot of fun sewing
and a lot of success and compliments
with the beautiful turntable bag.
Let's go!
These are the lower parts.
We need this part twice.
This part is for the cord.
You can also make it from another color
or from the color of the inside of the bag.
For a better understanding,
this material down here,
then it is easier to understand
and clearer when sewing.
We also need that twice.
Then the small parts,
which will be the loops.
We cut out the whole thing now.
These are the first parts of this material.
Then we continue with the cord.
We also need this part twice.
This is the upper part.
I put the fabric on top of each other.
Then I cut out the two at the same time.
We take this part twice.
This will be a small inner bag.
This part is the inner bag.
We also need this part twice.
I put the two fabrics on top of each other
so that we can cut it out twice.
We sew this part down here,
up to here and down here,
about up to here,
so that we can fold it well.
We fold it in at the end
and sew this part.
Then it is destroyed and all parts are clean.
We can then put this part on the inner lining.
These are the lower parts.
These are the upper parts.
We sew this together here first,
fold it up
and stitch through here again
with this part and also with the other part.
First, we sew the loops.
The loops are fastened at the bottom of the inner bag.
We put them together in the middle
and fold them together again.
Then we pin the whole thing down.
Just like this.
The second.
Now we put the inner bag on top
and sew the upper part of the bag together
so that we can sew it together
with a width of 1 cm.
Then we fold the seam up
and put the width of the foot
over it again.
We sew 7 cm from the bottom to the top
here and here
and fasten the loops
to which we then hang the cord.
We let it look inwards
and sew a width of 1 cm
just over it.
Just like this.
Now we sew the second part together.
We sew the bottom and the upper part
together with a width of 1 cm
and put the seam up again
and put the width of the foot
over it again.
Now we fold these two parts together
on the right side and on the left side
and make sure that when we sew them together
these two pieces
come together evenly.
Then I put a needle in
and sew a width of 1 cm again
and leave the top open.
When we come to the pin
we sew close to the pin
but then give it out
so that we don't sew over it.
Then we come to the loop
and sew over it again
and sew a corner here
and then up again.
The seams are not so tight here
but to prevent fraying
I put a little bit inside
down again
only on the part that frays more.
Here the same again up.
Next, we pull the corners away
the second one too
and then we put these corners
nicely over each other.
So the seam on the outside
and the seam on the bottom
make sure that they meet here.
Fold the seams away from the corner
and sew 3 cm up.
Then we measure up
exactly 3 cm from here
and make a line
and sew it away in the right angle.
And then we pull the seams
all the way to the other seam.
You have to be a little bit careful
and a little bit patient.
Then I fold the seams away
and sew them over here.
And we do the same
on the other side.
It is very important
that we finish the whole thing.
Now we can turn the whole thing around.
We put this in here
and here we put this in here.
We can also cut it away.
Then we already have a nice bottom
for our bag.
This is what it looks like.
Our bag bottom is already finished.
Then the lower part
is already completely finished on the outside.
Before we continue here
we have to do the inner part.
For this I thread a light color
because I have a light color lining.
This is the inner bag.
We fold it in the middle
and pin it down about 1 cm.
Just enough so that
we leave a part open in the middle.
Just like this.
Exactly like this.
So that it doesn't get dirty
we pin a few millimeters further inside
for the second time.
We leave a nice part open again.
Now we pinch the corners away
and turn the bag
through the open slit.
We give the corner out nicely.
We also push this corner out nicely.
Then the next one
until we have all four corners out nicely.
Pull through.
If we leave it open big enough
then it goes very easily.
If we sew it very tightly
then of course it gets more difficult.
Now we pin it down here.
This is the open edge.
We pin it down here
and now it's nice and clean for sewing.
It's important that we also
pin the narrow edges above.
We give away the remaining threads.
And here we have this little bag.
It doesn't matter if it's 8, 10 or any other size.
First we pin it through here
and we place it in the middle.
We make sure that it's the same distance
on each side.
And we sew it down.
We do this very carefully
so that it doesn't get dirty.
We sew it down.
I do it like this.
I start here at the top
and sew back again.
A few more stitches down
and a few more stitches up
so that we can pull out the weak point
at this corner.
We sew it up here
and a few more stitches down
and a few more stitches up.
And this little triangle
gives me a lot more support
than just starting here.
The life of such bags is considerably longer.
Right to right
we give away the needle.
Right to right
we give away the other part.
Here is the top.
We leave the top open again
and sew a centimeter to the side
like with the little bag.
And here it's the same as before.
We leave a piece open again
about 10 centimeters.
We'll see why in a moment.
We sew it up here.
And because we want the bag to be long
we stitch here at the seam
about half a centimeter through again.
Now we turn around again.
Now I still need these two parts.
This is for the tunnel pull.
You can use this color or another.
But that's a matter of taste.
This will be the little tunnel
for the tunnel pull.
We stitch here
two times half a centimeter.
We stitch here two times half a centimeter.
Now it's sewn up nicely.
And we fold it down again.
Here too.
Now we fold the strip for the tunnel pull.
And we pin it
starting from this seam
more often.
Again the beautiful side to the beautiful side.
The same over here.
We fold it in the middle again
and pin it.
Now we take the inner bag.
We haven't turned it yet.
We put the outer bag in the inner bag
so that the beautiful side
is together with the right side.
And we pin it nicely again.
The seam right in between here
so that the seams are overlapped.
We pin it all around.
We choose a starting point
and check again
if all four parts are overlapped.
And then we start sewing.
Again one centimeter from the edge
to the inside.
Now there is not much left.
Then we have our bag ready.
I always put the pin back out.
We left it open here.
Now we pull the whole thing out down here.
Be careful not to tear it here.
Two seam ends.
This is the inner bag.
And now we have to
pull out the corners down here
and pin through the hole.
To do this, we turn around again.
We bend the centimeter back in
and pin there again
Now we are almost finished.
It looks pretty solid already.
There is the inner bag.
Now it's time for the turtle bag.
All we need now is the cord.
At the end we
take a safety pin
and pin
the cord with it
and then push the cord through the tunnel pull.
Here it is important that we start with the other side.
So, let's pull that through here too.
We give ourselves an end through this loop,
which we sewed at the very beginning.
And with the second end we make a nice double knot.
So, we pull it nice and tight.
So, and on the other side the same.
So, at the end we pull the bag together
and have sewn a beautiful piece.
Inside, with the inner bag for the mobile phone or key.
And good luck and success in sewing and a lot of fun in wearing.