Truss Rod Adjustments

TheGospelGuitarist
1 follower
1 Video View·Apr 1, 2026
How to adjust your truss rod on electric and acoustic guitars.
AI Generated·May contain errors
Hello and welcome to Guitar Tech. Today we're going to learn about truss rods on electrics
and acoustic guitars. If you sit down your guitar neck you'll notice there's a slight
bow in it, at least there should be. Either a forward or back bow, usually a forward bow. So
holding your guitar normally using this ruler as an illustration, if your neck is shaped like this,
this is of course an extreme exaggeration, this would be called back bow. And if the nut
of the guitar neck, which would be right here as you're looking at your guitar on this end
where your tuning keys are, if it's bent up like that then you have forward bow. So you want to get
somewhere pretty straight. Usually there's a little bit of neck relief of forward bow just
so you can avoid the fret bus. Well on most electric guitars you will find a truss rod cover
on the headstock. It's just a plastic cover with a couple screws in it, in this case only one.
And you'll want to remove that to reveal the truss rod that actually goes through the entire length
of the guitar neck. As you can see there's a hex nut inside the hole. You're going to want to use
a hex wrench to get at it. And righty tighty lefty loosey is the rule. And only quarter turns usually
are needed at a time. So you're not going to want to just crank on this guy because you can damage
your guitar neck. Just make real small increments. That's usually all you need is one or two
quarters of a turn on a guitar neck to adjust it to where you need it.
You want to relieve the tension on the neck by loosening your strings before you do this.
So that the neck will be free to move. So you don't want to have the tension of the strings
on there. Now other guitars you might like on some fenders, I've seen it at this end where
the end of the bolt-on necks are exposed and sometimes you can see the access point there.
Okay for the second part of this lesson we are looking at my acoustic guitar right now.
This is pretty common amongst acoustic guitars that instead of the truss rod cover being up at
the headstock of the guitar you're going to find that you have to go through the sound hole between
the strings looking under the sounding board and you will find a hex nut adjustment screw there.
Now be sure that when before you adjust necks on either acoustics or electrics that you remember
to loosen the strings first. That means that takes the pressure off of the guitar neck so that
the rod inside can turn without strain. So always loosen the strings up and on an acoustic you want
to be careful because this is steel and these are steel. So when this rubs against these it can
damage them and fray them a little bit causing your string to break or whatever later. So make
sure you get these strings out of the way. Same deal righty-tighty lefty-loosey okay righty-tighty
lefty-loosey. So no matter how you look at the guitar neck whether you're at this end looking
towards the headstock or at the headstock looking towards the bridge it's righty-tighty lefty-loosey
okay and small increments and that'll do you
