Angled Router Jig Custom Woodworking Jig

The Stone Cube
31 followers
20 Video Views·Nov 3, 2022
Angled Router Jig Custom Woodworking Jig
Hey everybody welcome back to my channel today I'm going to show you how to make this angled
router jig so stay tuned and check it out. Alright so typically in my videos I do some
type of instructional voiceover but for this project I kind of was making it up as I went
so I don't think I'm going to do that for this one but I hope you guys stick around
and watch this video and maybe get inspired to make some of your own custom jigs for your own
projects.
Alright so we got the jig all made. I put the router in here just got to tighten this down.
Alright so alright so that's in place tightened down nice and secure. I actually I took this
jig and I put a couple grooves in here I just ran that through the table saw. I forgot to film that
but it's pretty straightforward. I ran that through the table saw to get these two grooves right here
and then I threw together this little corresponding plate. This is just going to get mounted to the
work surface with a couple screws right here and then these grooves are going to slide along this
rail just like that. Alright and just from a different angle we're going to set this on here
like that and then it can just slide back and forth and then your work piece the piece that
you're going to be cutting groove in is going to sit right up here and that's going to create a
groove. After that I decided I wanted to cut in a groove for a small shelf to slide into along the
back of the stand. This would be a nice place for my hard drive to sit on and out of the way.
Also since it was along the back side of the stand unless you're looking at the stand straight on
you won't even know there's a shelf back there. So I threw together this quick sliding router
jig and cut an angled groove into each leg. The blue tape is just there to help prevent chip out.
So yeah that's pretty much all there is to it. I realize that this is a very specific
jig for a very specific task but in this case it worked out well for me. It actually worked out a
lot better than I thought it would and it really only took me like a half hour to throw together.
So it's probably not going to get a whole lot of different uses out of it. You know it's only set
up to be a 45 degree angle there's not a whole lot of adjustment this way but like I said it
worked out perfectly for the task that I had on hand. Now I also realized that you guys are probably
not going to make this same exact jig but hopefully this project kind of sparks some ideas
for you guys and making those kind of one-off jigs of your own for the projects that you're
working on. But in the off chance that you guys do have this same exact trim router and you want to
make this same exact jig I'll take some dimensions of this I'll measure it all up and I'll put
together a drawing for you guys. So if you're looking for that check out the description box
below there'll be a link to that drawing. If you guys enjoyed this video make sure to hit
that like button down below that just helps me out a lot and I really appreciate it. And while
you're down there if you feel that I've earned it consider hitting that subscribe button as well
that way you're notified every time I release a new video. Like I said I hope this sparks
some ideas for you and your own projects and until next time thanks for watching.
