Hansgrohe IBox Shower Valve Tub And Shower

Repair house
9 followers
Nov 14, 2026
AI Generated·May contain errors
The contraflow valves are pretty nice
because they got a minimum-maximum sticker on here.
This has a nice flat base, so you kind of really can judge easily.
So just as long as your finished tile work
is in between the minimum and the maximum,
you know, I always try to go for the middle just
so if you have a little bit more thinset, it's not a problem.
But you really, you got quite a bit of distance here.
You almost got, what is that?
You got one inch.
One inch of space of fudge room.
So you really have a lot of room
for error as far as that distance goes.
So let's just take a look.
Our level is one inch.
So we're going to still have an inch and a quarter,
or we're still going to have a quarter inch beyond that area.
So that will end up being right in the middle there.
So that works out pretty well.
So this is a PEX fitting, half inch to three quarter inch.
It's a male adapter,
so it has the threads and then the half inch adapter for the PEX.
You need some pipe sealant.
Rotate this around your fitting clockwise,
four to five revolutions.
So on each one of these, try to keep your Teflon tape flat,
but going clockwise, when you thread this into your fitting,
it'll keep the Teflon tape on there
and thread it tighter as you go in.
If you thread it the other way,
then you'll loosen up the Teflon tape.
So try to keep your Teflon tape nice and flat and straight,
four to five revolutions.
Then on top of this, you wanna put some
Pipe sealant. Okay,
so before I install
this, it is easier
just to get all your
your extended pipes off of here first.
So we'll get our PEX. Okay, so you just have to make sure
that you have the indicator saying top. So this is up.
This will be the shower port. This would
be the cold. Cold
is always on the right.
Hot is always on the left.
Not all valves or
All right.
Basically, not all shower ports are going
to be able to use a half-inch nipple like this.
Sometimes it needs to have copper, but in this instance,
they just have a half-inch nipple that threads on for your tub spout.
So always pay attention to the tub spout that you actually are using
and make sure that you're using the appropriate connection to it.
So in this instance, there's just going
to be a half-inch brass nipple that will be coming out of this.
Let's do this.
So we're going to go off the center
of what our plumbing drain is.
Not necessarily what center of the outside edge of the tub
because it's actually, I mean,
this is a 30-inch tub. That's 15.
But our actual center of our drain is 14 and a half. So we want
to make sure that we just stay 14
and a half, the actual center.
Okay. So we'll use some elbows,
some
nine-degree
half-inch PEX
elbows. Now
for the niche.
So we were
planning on
putting this
directly in the center
and rerouting our shower head up
to the top. So since this is a
non-load bearing wall. I'm just going to put this flat ways.
That's so when I put my niche in
here I have plenty of blocking to screw my other board into as well.
So it's kind of nice putting
that two by four flat ways
so you have plenty of plenty of area to screw your fasteners with.
Homemade
test plug.
Basically
have a male
adapter
and then a
copper cap.
