Chemical kinetic || rate of reaction between sodiumthiosulphate and HCl #12thchemistry #practical

Hello, friends, this is your practical, this is the 12th-grade practical, and it is Practical No. 4, which comes after Chemical Kinetics. In Chemical Kinetics, it is stated that the rate of reaction depends on the concentration of one reactant. I mean, if we increase the concentration of GSE in Reactan significantly The reaction will go forward at a faster speed. So practically, this is your 12th board practical number 4, which I am showing you. Chemical kinetics Sodium thiosulfate The second one, then the third one, then the fourth one In such a case, what should be done continuously? How do I start it? How do I turn it on? Let me show you how to start the practical session. So fronts, these are with me I'll show you how to start Barat kiita, our wedding is all set. Now we don't need to mention that salt, but we do need to distill sodium thiosulfate and the residue. However much was supposed to be given in our hand book You must be tired. Put that much in A, that much in B, that much in C as well, and that much in D. As much as you have been defending me, I have seen Inshas Dheejnaji, it's time to take action. The wild animals are the only ones who have remained with us. You shouldn't be making fun of me. When should you apply the seal? As you are going to set the timer, you will have to set the stopwatch. Why will Turant be? Na₂SO₄ and salt interact with each other By cheating Made sulfur which is yellowish in color It is white yellowish in color. And as soon as it happens here, what will happen? will be formed We need to add 20 ml in the pelve valve. What should be added? 20 ml sodium thiosulfate second in the bottle, 30 ml Next in the vavale, 40 ml And pour 50 ml in the last funnel. We will do the full job. No, but the water will play. The river that flows over the caper here very much In the first one, take 28 ml of water. Add 18 ml of water in the second one. Add 8 ml of water in the third one. In the last D-type one We need to take some water. How much should I charge here? 2 mL 2 ml basically, if I were to speak, this is approximately That's it, 2 ML SCL I'll take a detour; I'll have to stop watching immediately. And look, I've just covered it up. The stop watch is already running; I'll just reset it slightly. How long do you have to keep this on the Uber? The whole of the whole white precipitate Or else, it will turn yellow into white. And you have to look at this naked item It's been here for two minutes; now I'll just discard it. What will we put in the other one as well? Two MLSCL back again And let's see what happens here. I've just added 2 MLSCL. I will scold him for this. I'll restart from the beginning. Now this is the last one we have. We will go in the last one. What is this? Back in the very deep, dark night, they recite the Ganges, trembling with fear. Because it contains more warder-malekil. Therefore, this entire reaction is good. This completely obstructs the flow of the reaction. And you know the last one—I added water to it; otherwise, it would be way too dry. What is its rate of reaction going to be? It's increasing. I mean, it seems too late for it to precipitate. What will happen? You can see it's going to tear apart, tear apart It has already started here, so it's about ten seconds. Inside, this entire precipitate will form, so friends, this Cross Mark has finally disappeared. Now we'll see what happens. Precipitate