Technivorous is back with another Cura Questions video. this one from Andrew. he wants to know what setting determines the greyed out margin on the edge of the build plate, and how to make it smaller to utilize more space for #3dprinting!
Like and Subscribe!
Send me a gwei! (ether address, all donations accepted!) 0x95F4EaB8A738F4F27e7c04aEe1E10C8E666C2D0c send me a satoshi! (bitcoin address, all donations accepted!) 31zvj8ybxVVTLw6nPvAHYqu3qDVhC1sRqk
Want to send me something? Technivorous 902 n Hughes Blunt Sd 57522
AI Generated·May contain errors
Video Summary
AI Generated
This video provides a tutorial on how to adjust the grayed-out \"protected\" border area on the print bed in Cura 4.10. The presenter explains that this area is determined by the selected adhesion mode and demonstrates how to modify specific settings to reclaim more printable surface area.
Hey folks, TechNiverse here. We're going to slide to the left here, and I think that should do.
Okay, so we have another Kira question today. The question is from Andrew Hayes again.
I have downloaded 4.10 and added my Ender 5 Plus printer with a grayed out border to protect the area of the bed.
Clips Occupy is now four squares deep when it was only one square on 4.9.
Is there a way to change this back to one square?
Okay, so the area Andrew is talking about is this grayed out area here, and that is determined by your adhesion mode.
So yeah, you can change it, definitely. Right now it's at the skirt. Skirt distance is 10, and minimum length is 250.
So for the skirt, if we were to change this distance, it changes the grayed out area.
So reducing the skirt distance will give us more surface area to print on on the bed.
Increasing the distance will give us less.
So you're going to want to reduce this number, and it works about the same way for the brim as well, except here it's minimum length.
And for the raft, the setting you're looking for, it's actually not showing yet, so what you're going to want to do is type raft up here.
Get a list of the other settings, and the setting you're looking for is this extra margin setting.
So if we set that to, say, five millimeters, we have a much larger area that we can print in.
So that's basically the gist of it.
The problem that you're having is due to too high of a perimeter in either your extra margin setting or your skirt distance setting.
So let's try, see, I can reduce it quite a bit if I want to get a large raft.
Now basically this is telling me it's going to print the raft 50 millimeters away from the edge of the object, which in this case would work.
But in this case, 50 millimeters away from the edge of the object is off the bed, so that's why it won't allow us to do that.
So just change that to something smaller.
Anything, as far as the raft margin goes, anything larger than two to three millimeters larger than your model will work.
The larger that margin is, the easier it is to peel it away from the model when you're done.
So keep that in mind as well.
That's going to be it for this video, guys.
Andrew, I hope that was helpful.
I hope you get it figured out.
Don't forget to leave a like on this video.
Hit that subscribe button and leave your Kira questions in the comments because I make these videos for you, and I wouldn't be able to answer questions if I didn't get any.
So feel free to drop me a line and let me know what you think and what you want to know, and we will jump on and make a video just for you.
That's going to be it for this one, guys.
TechNiverse out.