โโโโ ๐๐ฒ๐๐ซ๐๐ฎ๐ฅ๐ข๐๐ฌ ๐๐๐ ๐๐ญ ๐๐ง๐ข๐ฏ๐๐ซ๐ฌ๐๐ฅ ๐๐๐๐ก๐ง๐ข๐๐๐ฅ ๐๐ง๐ฌ๐ญ๐ข๐ญ๐ฎ๐ญ๐! โโโโ

Charleyโs Garage
78 followers
A quick tour of the hydraulics lab at UTI (Universal Technical Institute). A look at the training aids we use to teach the class and just a few of things we go over in the class.
#diesel #hydraulic #UTI #training
All right, this is the hydraulics lab at Universal Technical Institute and I thought I'd give you
guys a tour of another class that I teach. So we got the equipment here that we do different labs
on such as cylinder remove and replace, how to bleed cylinders, how to remove and reinstall
hydraulic pumps, how to do PMI inspections on equipment. So we got the cat, we got a couple
of trenchmen, ditch witch, but most of the learning that we do in the labs come from these guys right
here. This is what we call the cavitation trainer. The cavitation trainer we use to teach what
happens when you have a restriction in the inlet and teach them how to read a vacuum gauge to
understand the difference between aeration and cavitation. You have a tube here, it's the pump
inlet and it'll show you what the fluid looks like when fluid's restricted going in. Another
tube shows you what it looks like when it's coming out. It has a flow meter on it so you can see what
the effect of aeration and cavitation has on flow and it has a pressure gauge so you can see the
effect it has on pressure. And then our primary training is this board right here. This is a fluid
power NF100 board and as you can see we have a lot of them right. So when you're in this hydraulics
class you're going to learn basic theory about hydraulics and understanding what flow and pressure
to do, what pumps do, and then we go into specific categories. So one of the chapters we'll go over
is actuators. So we'll talk about hydraulic cylinders, different types like single acting
and double acting. Then we'll cover hydraulic motors. Then we have a chapter that will specifically
go over pumps and fine movers and then we have one over different flow control valves. So we'll
talk about basic needle valves, flow control valves, pressure compensated flow control valves.
Then we have relief valves. We got a basic one right here and then a pilot operated one.
We have a part that goes over directional control valves and how they operate and the students will
bring lab sheets out here that shows them a schematic of a hydraulic circuit and they use
these hoses to build that circuit and do their tests. It's a pretty interesting little setup
that they got here and these boards work wonders at being able to explain basic things about
hydraulics. It's one of my favorite classes to teach maybe right after diesel engines so
I'm looking forward when I get a chance to get back in here and teach this class.
