Making a drywall repair

VideoJoeKnows
63 followers
21 Video Views·Jun 2, 2026
http://www.VideoJoeKnows.com Making a drywall repair "can" be an easy "chore".....if you know how. Drywall repairs seem to always pop up when you least expect them. It's about time you learn how to make repairs to your drywall "then" you can start saving money. Making drywall repairs really aren't that hard to do......when you know how. Watch as "joe" does a drywall repair.
http://www.VideoJoeKnows.com
I marked these areas with the pencil when I checked the wall and I remembered there
are some spots here so I'm glad I marked those with my pencil.
I might have forgotten.
I'm just going to use Kwikset and I'm going to put over there.
That's just going to help fill up that area without this sheetrock mud shrinking on it.
So that's all I have to do.
That's the first coat I put over there.
I'm going to use a 6 inch blade here.
I'm just going to wipe this down, scrape it down slightly.
See if there's any lines in the first coat of Kwikset.
I'm not going to wipe too much.
I've got just a little bit of Kwikset here.
I'm going to float over these two little patches.
As I'm putting the mud on, I'm keeping it tight to the left hand side.
Pushing it off tight to the left hand side here.
Pushing it off tight to the right.
In the middle, I'm floating it flat.
Then push tight to the left.
Wipe off there.
Push to the right at the bottom.
Pushing at the bottom and letting the middle float.
Pushing at the top and letting the middle float.
That's how.
Right down the middle.
That's looking pretty good.
See how I did that?
Now, once this dries, this will be ready for the final coat.
For the final coat, we're going to use the all-purpose mud or the topping mud.
Do not use Kwikset for your final coat.
I'm going to finish over this with regular sheetrock mud.
I've got two coats of Kwikset over this now.
I'm going to take some mud. I've got my 6-inch knife here.
I'm going to make this patch wider, taller now, and longer.
So it floats in.
Wiping off my edges.
I'll put it on.
More pressure at the bottom.
And float up the top.
More pressure at the top.
And float the middle.
Now, I'm going to show you.
This is a 10-inch blade.
You want to get some just on the tip like that.
Wipe off the edges there.
And this will really do you a good job.
Way better than your 6-inch.
Wipe it off and just try to grab some on the tip.
Put that on.
See how much bigger our patch is now?
There you go.
Now you let that dry.
And then you can lightly sand it.
And then you're ready to prime and paint.
