How to shim out a "crooked" door latch

VideoJoeKnows
61 followers
1 Video View·May 29, 2026
http://www.VideoJoeKnows.com How to shim out a "crooked" door latch.....do you know how to do this? No "special" tools required to know how to shim out a door latch that is crooked. The crooked door latch is just on the side of the door so what difference does it make or "how" it looks? It's only your reputation at stake...that's all. Get in the habit of making "your" door latch installs nice & flush...even if the old door latch, you're taking out, was crooked....how "bout" that? Watch as "joe" shows you how to shim out a crooked door latch "notch".
http://www.VideoJoeKnows.com
This side here is pushed in further than flush.
That's because the old door latch was like that
and they didn't take any care in mortising that out
so it's flush.
Well, I wanna try to make that nice and flush like that.
But I can't, you know, if I put the screws in nice and tight,
I'm gonna have this recessed in there.
I don't want that.
I like to have my stuff looking nice and flush.
And I'll show you a trick on how to do that.
Now here's part of the door handle that I got.
And it's kinda like cardboard.
It's not really cardboard, but it's heavy enough.
So what I'm gonna do is I'm gonna cut some of this
in a long strip and I'm gonna fold it over,
fold it over until however thick I need.
And I'm gonna put that back up in there
and then push the latch in there and see what happens, okay?
Got this on there.
I could do this a couple different ways.
I could hold that up there like that
and cut that off right there.
And then I just fold this over itself
about two or three times.
In fact, that's what I think I'm gonna do
because it looks like it's sunk in
about the same thickness all the way down.
So I'm gonna hold that there and cut it and fold it over.
You can use anything you want.
I don't like to tear them off.
I just use my 10 snips and cut that.
And then I'm gonna gently fold this.
I gotta make it really small
because I don't want it to hit those screws
or the side of the latch, right?
Okay, I've creased it.
I've got three layers there now.
I think that's about right, but let's say I'm wrong
and I suck it in and it's still not perfectly flush.
What I'm gonna do is I'm gonna fold this over one more time,
crease it again, then I'm gonna put that in there.
If that doesn't work, if that sticks out too far,
which I think it will, then I can unfold this one go
and cut that off and I'm all set.
Okay, now I got four layers there.
So any excess that you have left, just cut it off.
So I'll just use my 10 snips again
because this works really well.
Just trim that off.
Now I'm gonna take this out and put this in.
I can just fish it in like that
or if it's not holding,
let's say you got just a little piece up there,
you can wet that and just stick it up there.
All it has to do is hold up there
until you get the latch up there, you know, like that.
Take my little screwdriver
so it doesn't wanna fall down on me,
making sure it's flat and push that in.
Okay, now look at that.
I'm glad I folded it over that fourth time
because that's perfect.
