PreSonus Studiolive 16.0.2 Metering Section

TheGospelGuitarist
1 follower
Mar 27, 2026
A quick look into the metering section of the 16.0.2. and how the Fat Channel meters are used in conjunction with the meter switches to monitor input, output, gain reduction and fader level positions..
Welcome to my series on the Presonus StudioLive 1602 digital mixer.
All right let's take a look at the metering on the unit now.
On the left of the side of the faders you'll find four buttons. One labeled input, one output,
one is GR for gain reduction, and the other one is locate. Now when you push the inputs
switch you will see that up on your meters you will get readings for your channel's inputs.
So the mic I'm using is on channel 3 right now and it's going to show me how strong it's coming
into the board before it hits the fat channel. Over here I have a CD player just for the use
the video so you can see some meter action. And if you go to output the last six on the right
will be all of the outputs of the board. So the channels 7 through 16 are used for
monitoring your auxiliary 1, 2, 3, 4, and then the ones you see are your main output for left and
right. So that's your output metering. Gain reduction will be showing the compressors
if you have them engaged on the channels that you're using. And in this case I have two compressors
running on the board right now and they work inversely from top to bottom instead of bottom to
top. So you'll know instantly when you hit the gain reduction instead of the output button
because they're going to be upside down. Hitting the locate fader button will tell you where your
faders were with the scene that you loaded. If you load a scene or this in this case is the default
which would be in the middle. If I had a scene where I had saved all these special places I
wanted the volume controls I would have my faders in a certain place at the end of a scene and I
would save it. So in that scene it saves all of my locations for my faders. So when I reload the scene
I can then see where they should be and place the faders matching up here where it says they
should be when I saved it. So you don't have to worry about remembering where everything was because
this unit does not have motorized faders. You're the motor in this case and so we need to have
these little lights up there to tell us where to put things. And so that's your metering for the unit.
