PreSonus Studiolive 16.0.2 FX and Aux Sends

TheGospelGuitarist
1 follower
4 Video Views·Mar 27, 2026
How to operate the FX and Auxiliary send controls for mono and stereo sends.
AI Generated·May contain errors
Welcome to my series on the Presonus StudioLive 1602 Digital Mixer.
Okay, let's take a look at the encoder section of the board.
If you look off to the left of the fat channel,
you'll see a row of buttons labeled encoders,
and you have your effects A and B,
and then you have your auxiliary one, two, three, four,
and one and two have a gray box around them,
as well as three and four.
There's a light box that goes around
the selection of buttons,
and there's also a light box that goes
around this row of knobs,
which connects these to these visually.
Another thing you need to worry about here is,
not necessarily worry about,
is make sure you take note of the channel numbers
underneath each of the row of LEDs.
So the first thing we're gonna look at here
in this group is the effects.
So you have effects A and B,
and they all work the same way.
Each knob is going to adjust your effects send from,
in this case, channel one.
I can adjust how strong I want channel one
to be sent to my effects A inside the machine,
and so on.
I can adjust two and three and four.
All these will go to the same effect, say it's reverb.
So you're putting reverb on a drum kit,
and you have different parts of the kit,
and some you want more, some you want less.
And so that's all there is to it.
Each knob will be an effect send for effects A.
Exactly the same setup for effects B.
They all work the exact same way,
and that's it for your effects section.
So each knob is an effect send control.
When you get into the auxiliary section,
it gets a little bit different.
If you're running all of your auxiliaries separately,
then each channel knob becomes an auxiliary send control.
So you can control the level of the send
going on each channel,
pretty much identically to the effects A and B setup.
And that's exactly the same way for two, three, and four.
However, when things get different,
and you go over here and you select your auxiliary one,
and then you link it to auxiliary two,
so now you wanna run these two controls in stereo.
So that's gonna change the way things work a little bit.
Auxiliary one button is going to be your send
for the grouping of auxiliary one and two.
Auxiliary three is going to be your send
for auxiliary three and four,
if you are pairing those as well.
Otherwise it would work separately as usual.
Now, the aux two in the pairing
is going to control your balance.
Notice it starts in the middle.
And so when you turn the knob to the left,
the indicator goes down,
indicating that you're panning to the left,
and up is panning to the right.
So now instead of only the send control,
you have send and panning
because you're running auxiliary channels in stereo.
So that's all there is to working your encoders
for your effects and your auxiliary sends.
