PreSonus Studiolive 16.0.2 Graphic EQ

TheGospelGuitarist
1 follower
Mar 27, 2026
How to apply the mixers 31 channel graphic equalizer to the main output bus. Also saving and loading presets discussed.
Welcome to my series on the Presonus StudioLive 1602 digital mixer.
Okay let's discuss the board's graphic equalizer which is available to use on your main outputs
of the mixer. You're going to go up to the left side of the board in the top corner where it says
encoders above your other encoder buttons and says GEQ. So when you push that all of your meters are
now going to reflect different frequencies in the 31 band equalizer and your display over here will
change to show the band that you're on the frequency of that band and the gain and your
EQ status which is the actual 31 band equalizer not just the one channel shown. If you turn it
on all 31 bands are on. It also reads push recall to flatten. So if you have say all of these
encoders all over the place and you want to start over you're at a new location hit the recall button
and everything gets reset for you. You'll also notice that channel one is inverted that's because
I have channel one selected in the display here. Now the encoder knob you can choose to scroll
through all 31 bands as you go across the end it will flip to the next row and go all the way
across. Now if you notice if I go back these two don't switch and that's usually because you're
going to be running outputs and it might be monitoring your output there. Then in the
next round it does use them and then on the third round the first three are skipped because there's
31 bands so they've broken it into three passes here. So when you get it all set up this is going
to be applied to your main output front of house and also the quarter inch output jacks. Now if you
get things all set up each one of these encoders are going to work with each frequency on the board
and when you get something set up that you like you can press the save button to save that setup.
Like if you're the different like if you're the church and you run the things there and you don't
want to keep EQing the building you can save your settings. So it's going to change in the display
to give you the GEQ presets and you can use your encoder knob to find the location and name a
location and save it. And then later when you're touring around or whatever you're doing you might
hit a bar next week or something and you need to load a different one you could hit the load button
and load Pat's Bar or whatever location you want to name it as and then it will reset everything
the way you had it the last time you were at that location so again it's a time saver.
So that's how you apply the EQ to the main bus.
