Pottery Tutorial - Pulling Handles

Art Galleries Worldwide
11 followers
2 Video Views·Feb 16, 2026
Hi welcome back So today I'm looking at handles I've never really used any other techniques
To be honest I know you can extrude handles or use a wire to cut through the clay
Because we all have different hand shapes you'll find that when you pull the handles
ey’ll have their own distinct look and while yours will clearly differ
from mine that’s exactly what makes it great—you’ll make it truly your own
something unique about it So this is just a simple introduction to pulling handles—
go ahead give it a try and see how it goes I can guarantee that if you haven't already
done it before you'll probably pull the handle straight off or it'll break but I'd keep going anyway
and it might take somewhere around 10 15 or 20 tries but just go for it and over time you'll begin to
get the hang of it and then you'll start giving your handles their own
unique style So yeah I hope you enjoy it and let me know how you get on
So it all begins with a lump of clay weighing around 800 grams I usually aim to
Choose a piece of clay that's very soft much softer than what I'd normally use for throwing
If you're working with softer clay it's much easier to shape handles so I begin with a basic cone
and a thicker section is held with my left hand I begin to pull the remaining clay The idea
s to pull the clay slowly and evenly without letting it break Once you've got it to a decent leng
And when it's about three-quarters of an inch thick you'ready to start breaking off the blanks
I just use a table and snap off the end with my thumb—aim for more space than you actually need
because there will be a few failures and it's beneficial to simply select the best ones
I usually keep some a bit longer than others since all my mugs come in different sizes
If a mug is a bit more substantial I usually go for a thicker handle so I do use thicker blanks
as well Once your blanks are ready place them on a surface that won't absorb the
water out of them I just put mine on the wheel where I work You'll also need some slip I usually
Just take a piece of clay make a small depression in it and fill it with water You'll also need a needle
ool to assess the area where you'll attach the handle Begin by determining where
You're going to place the handle and just begin scoring the top section— it doesn't need to be deep
Just enough to lightly roughen the surface I also apply a small amount of slip to further soften the area
Once I've added the slip I'll sand it again which also creates a very nice surface for the handle
o be attached Once more try not to go too deep—just score the surface so it has something to
Stick to your choice—pick either the large or small blank then simply tap the
cker end Once you've achieved this score it and add a bit of slip What you're aiming for is a
somewhat oyster mushroom-shaped once you're done put your hand inside and suppor
Support the rim by placing the back of the scuffed area against it—don’t distort it at this stage
Carefully press the blank onto the cup and give it a slight wiggle to ensure it's securely attached
before you begin smoothing it into the body—just do it roughly for now since you can always refine it later
back to it later once you've shaped the handle Once you'ready to pull the handle hold the cup
right in front of you with the handle pointing down at a 90-degree angle—just gently guide it using your thumb
Pull the clay until it stretches out again just as you did before with the blanks I begin at the center
and then pull each side so you end up with three sections that have been stretched Once you're
satisfied with the thickness in the cross section gently pull the handle around and attach it to the
bottom The moment you try to fix it it just makes
things worse so take your time and get it right in one go
