Arrow Clearance and the Importance of Nock Indexing

The Technology of Old Crossbows
4 followers
20 Video Views·Jan 29, 2026
Arrow Clearance and the Importance of Nock Indexing
Comments are disabled for this video.
One of the most important things you can focus on right now is knowing that your bow has clearance
from your fletchings. This is so important because right now people are going crazy trying to choose
their fletching style or fletching configuration, all the above. And I've noticed this a lot at the
tack events when people would twist their three fletch arrows to where they would twist it to
the cock vane would be down so that their top two vanes could clear their housing better.
And what I started telling people is just because you're looking at the clearance on the top
doesn't mean that that arrow is clear. There's multiple places for clearance. There's clearance
at the top, but there's certainly clearances on the inside. And this is really important because
on some brand bows this inside clearance is really tight. The best thing you can do
is knock that arrow and you really have to look down it. Make sure you have clearance from the
cables. If you turn this this way to where that's pointing straight out, well on this particular bow
I still have clearance but it is critically close. Once this starts to turn up I start running the
risk of with this vane and again this is why I choose the max stealth vanes that I use because
it's a longer lower profile. It's quieter but it also gives me a little bit more clearance.
Taller vanes can steer better, however it comes with the cost of clearance. Now here's something
I want to talk about. In this case right here, sometimes I shoot all my arrows in an X configuration
and the reason I like that is when it's in the perfect X configuration I have the best clearance
on the top and I also have the best clearance on the bottom. But you can see I have the best
clearance on the cables. That's why I like the forefletch in an X configuration. Now if your X
is a little bit tilted like that, doesn't seem like much does it? However if I remove this arrow
and show you the rest right here you can see that there's a little bit of scuffing right here on
this right edge and that scuffing is from when I replaced my nocks and I didn't pay attention
to the indexing. That's what this is called, nock indexing. I did not pay attention to the indexing
and that rear right vane was turned down and again you have to look at this.
So if I flip my rest in the down position but hold my arrow at the 90 degrees I'll look and see that
even this long low profile vane it can hit this lower right edge if the nock isn't positioned
correctly. So one of the steps that I do on my arrows when I put those nocks in I make sure the
nock tightness in the shaft is good but then I'll look down the back of this arrow and make absolutely
sure that I'm not getting any contact there. Now some people will spray foot powder on their rest,
some people can spray some foot powder or even if you put a little bit of lipstick
on the edges of your vanes you can shoot them through your bow and you will get an identifier
of where you might have contact. There's certainly some vanes that have less clearance than others,
plain as day. They might steer well but you're really running the risk and on certain model bows
this gap gets really close. So pay attention to your nock indexing and if you make every one of
them the same the next thing that you can do once you've checked that alignment is go ahead and make
a black mark right here on the side with the fine tip sharpie to where that line will tell you if
anytime you twisted this by accident you'll see those lines are off as you're loading your release
and you'll know that your nock indexing was not correct. We're gonna smoke that panther
with a perfect indexed nock. Oh yeah.
