Conservation of a Romano-British Urn | Episode 8: Mould Making and Resin Casting

Historic Conservation
284 followers
3 Video Views·Dec 8, 2025
Episode eight in a weekly series that tracks the in-depth conservation work on a Romano-British cinerary urn.
Cinerary urns were designed to carry ashes, especially the ashes of cremated bodies.
Follow conservator, Dr Duygu Camurcuoglu as she conserves this beautiful glass object.
If you remember last time, I started making some gap fills for the glass urn,
which I will then place in the missing areas. These fills would act both as support and
aesthetical fills. To make a mould for my plaster fills, I decided to use the two-part
moulding and casting technique. Firstly, I used a plasticine to create a plasticine base
for my plaster fill, and I also put some plasticine underneath my fill to raise it slightly
over the surface of the base. Following this, I have this solder, which I cut into pieces,
and this is going to create a keying for my two-part mould. This is an old example of
two-part mould, and as you can see, they help the two-part mould to lock into each other.
Also, you can see here two bamboo sticks in order to create channels so that later on,
I can pour my epoxy resin through these channels into my mould to take a cast for my plaster fills.
As you can see here, I started building my wall along the edges of my plasticine
base. It's quite a simple process. You need a fresh and soft plasticine to work on this,
because otherwise it gets really hard to mould the plasticine itself.
So now, I will start making the one part of the two-part mould in order to take the mould
from the underside of my plaster fill. I'm going to start measuring the moulding rubber and the
which will be about 400 grams of silicone rubber to five drops of the catalyst,
and catalyst actually helps fastening the setting process of the mould.
Now, it's time to add around five drops of catalyst into it. Once I pour the silicone
rubber mixture into the plasticine walls, I'll leave it for about 24 hours, so until tomorrow
afternoon, before I can actually remove the whole thing and turn it around to start making the
second part of the mould. I had to prepare the epoxy resin about an hour before I start casting.
The reason for this is because when I mix the two parts of the epoxy resin, I have to mix it
really, really well, and this causes a lot of air bubbles within the resin itself. Even though the
urn has a lot of bubbles within the glass, I still do not want an excessive amount of air bubbles
within my resin fill. For this reason, I left it for an hour, and now it's time to pour it
into my mould. I prepared two plastic funnels by cutting plastic disposable pipettes, and I will
place one of them here, which I will pour the resin in, and the other one will go in here, so that I
can also monitor when there's enough resin in the mould, so that the resin might start coming up.
That means that I have enough resin in my mould, and I should stop pouring more.
So I put some resin into the funnel, and as you can see, slowly, slowly, the resin is going down.
As you can see, the mould is now full. It doesn't take any more resin inside the mould,
and I put my sign here saying that conservation in progress, please do not touch, and I just put
it here, so that everyone, they should not be kind of touching or trying to remove anything
from this setup here, until the resin has set.
