Conservation of a Romano-British urn (Episode 7): Gap fills

Historic Conservation
284 followers
3 Video Views·Dec 1, 2025
The seventh episode in a weekly series that tracks the in-depth conservation work on a Romano-British cinerary urn.
Cinerary urns were designed to carry ashes, especially the ashes of cremated bodies.
Follow conservator, Dr Duygu Camurcuoglu as she conserves this beautiful glass object.
Once I completed the reconstruction of the glass urn, I then started thinking about making the
fills for the missing areas on the object. And for this, I decided to use two different
techniques. One of them is moulding and casting, which you can see some of the previously made
moulds from another object. I'm using dental wax. You can actually put it in hot water or
gently heat it with a hot air blower to mould it into any shape you want. I use a lap seal to
actually cover the edges of the glass so that the fill material, like plaster or any other material,
does not go over the original surface of the object. I use several tools, conservation tools,
and also plaster, which I will be making my gap fills from. Before making the detachable plaster
fills before moulding it, I use the dental wax first. So I take a mould from a similar area on
the neck of the urn, and then once it sets, once the wax cools down, I place the wax inside the
glass to actually make it like a backing. But beforehand, the lap seal, I use it as a barrier
to cover the edges of the area that I will be filling. To make a plaster fill, I have this
little bowl and I fill it with a little bit of water, and then I start adding plaster. And for
this, I will need to use quite a lot of plaster until I can create a kind of a paste. So once the
plaster is in this kind of consistency, as you can see, it's quite like a putty-like,
so it's a bit like cooking really. And then I start applying the plaster with my spatula
onto the gap that I backed, I supported with dental wax and the lap seal.
Plaster sets very quickly, therefore I need to do this work quite quickly too. You have to put
the plaster in layers, and in this case, you can see the gap here is quite large,
but I decided to do it in two bits, because if I fill this in one go, there's a risk that once
the plaster is set, it may break. So I decided that I will do it in two parts. And it is very
easy to work with plaster when it's still wet or damp, but once it starts setting,
it gets a bit difficult, so you have to be quite quick. Once I make the fill, I then leave it for
until tomorrow for it to completely dry and set before I can actually remove the fill
from the object. After that, although the fill is made, there will be still lots of irregularities
and some scratches and some kind of application tool marks on it. As you can see in this case
here, or I have another example, I've already made one and started working on the surface
by smoothing it with several sandpapers. I actually wet the plaster fill, the surface
of the plaster fill, and then with different grades of sandpapers, I start correcting or
smoothing all the irregularities, scratch marks, tool marks, etc. I then use a conservation grade
like a putty, a bit like polyfiller, but this is like conservation tested, to fill in any kind of
holes or gaps, anything like that, because remember my aim is to make a perfect surface.
And once that's done, and once I decide that my fill is ready, I can actually start with the
mould-making process and then taking a mould and then following, make a cast of it by using epoxy resin.
