Closing the Garage Exhaust Fan | Fall 2025

TV Electric Fan
2 followers
4 Video Views·Oct 13, 2025
Closing the garage exhaust fan for Fall 2025. This is the iLiving ILG8SF20V-ST 20" 3,368 CFM wall exhaust fan I installed in 2023. It's worked excellent for 2 whole seasons now. This is quite a good unit, especially something made today. The only downfall to it is the shutter.
It's time to close the garage exhaust fan for the year.
This is an excellent fan, especially by today's standards.
But the shutter is awful. There's so many gaps.
You can see, even with the lights on in here,
you can still see all the light that's coming in.
This is letting in a tremendous amount of cold air, and it's very windy.
Today it's going to be very windy for the next couple of days.
So I think now is a good time to shut this for the year.
I can feel a draft coming in right now.
I haven't used it in a while, and I don't think that we're going to be using it for the rest of the year.
So, I saved, and actually remembered where it was,
the blocks of insulation I put on the bottom.
So we have those still.
I don't know where the piece of wood went.
I think I might have used it for something else.
Duh.
So I've got to make a new one.
I already took the measurement and marked this.
So we just need to put a right angle on here, and then go outside and cut.
That's the height, so it'll go on the fan like this, and this will be the bottom of the fan.
Lock up for the winter.
Should really just get a better shutter, because that shutter is abysmal.
I sealed off this room very well last year, in terms of weatherproofing, airtight the door, and so forth,
and it made a huge difference.
It cost a lot less to heat this room last year than it did the previous year.
Usually this is the last part of the house I need to run the heat in,
because it's block.
It holds the heat pretty well, and plus bringing the Kiron when it's hot gives a fair bit of heat into the room.
It was funny, I was talking to Kevin about the air conditioning in here in the summertime,
and I was surprised because the 18,000 BTU does not give a damp cool,
which means it's not oversized, but square footage wise it's grotesquely oversized.
And I think the difference is that there's so much mass in this room,
between all the air conditioners, and the vehicle, and the junk,
that it really just takes that much thermal energy to change the temperature of the stuff in the room.
This probably helps hold the heat too.
The heater in here is, I think it's a 14,000 BTU,
and I mean it's good down to like five or ten degrees, then it stops rising the temperature,
but good enough.
I haven't got the heater out yet.
Today is the first day I kind of wanted it, so I just have this one on for now.
This will do the job, you only need a couple degrees.
It's 65, 57 out.
Not much load on it.
Once I get this covered up, and I start moving around in here doing some work,
and get this area covered up, it'll get a lot warmer.
Okay, it's honking and what?
I'm not going to get out the power saw for this, it's not worth the time.
We'll just use the manual saw.
It doesn't really matter if it's that straight or not, I don't care.
This saw is, there's no chance of a lithium battery fire.
There is with the other one.
I saw right where it fell, but I don't see the bit itself.
Here it is.
It's not perfectly here.
That's much better than it was.
Should be a lot less drafty now.
