How To Place Ice Screws

Memories Transcend Time.
11 followers
5 Video Views·Aug 2, 2025
AMGA Guide Lindsay Fixmer explains how to place ice screws .
Ice screws are super strong.
The threads are what hold these screws in.
The length of that shaft just helps
to get farther into the ice.
Tests have shown at a slight upward angle
that the screw is the strongest.
This can be difficult to place,
so if you go perpendicular to the ice,
it's still incredibly strong and it's easier to place.
As you can see, these screws are only placed
with a few threads in.
They're still incredibly hard to pull out.
And if I were stronger, I could pull that out.
One way ice screws can fail is leverage.
If I were to pull down on this,
that will break that chunk off.
Similar with this one,
very hard to pull out, but the leverage on this,
well, okay.
If I jump on it, maybe if we get Pat and me,
I'm gonna back it off once.
I need to be way stronger.
This is my workout for the day.
There we go.
Ice screws are really strong and nice uniform ice.
Once you've found that uniform ice,
similarly to your crampons and your tool placements,
you want a concave space for the ice screw,
not a convex.
So not a bulge to place an ice screw.
Where we showed with that levering,
you can easily break that off.
You want more of a concave spot.
It's harder to get all of that.
For my tools, my crampons and my ice screws,
I'm looking for micro concave spaces.
Placing a screw on lead,
I'm looking for nice uniform ice.
And I also wanna be in a really good stance.
I usually play somewhere between my shoulder and my hip.
And I turn my hand as far as I can around,
start driving it once I feel it's sticky.
Then I start moving that through nice and smoothly.
It's helpful to have uniform ice.
One, because this is the strongest piece of ice.
It's also easier for me to drive it all the way
and not have to chip away and create that nice flush face.
So as I come into my next place to place a screw,
I wanna make sure of my,
the first things we talked about,
which was one, a good stance.
Another concept is the tools being out of my way.
And I want that nice uniform ice again.
If I place a screw close to my tool, I could knock it out.
Should be less than ideal on lead.
Having really sharp ice screws is really important
so that they'll actually start really well
and continue their drive.
I also don't wanna crank this past being flush
to the surface of the ice.
If you overdrive the screw,
it will compromise the strength of the threads.
Get a high tool that's out of my way.
When placing this last screw,
it takes a lot of energy and a lot of pressure
and force behind my drive.
This is why it's helpful to place around the waist
to the shoulder region.
So as you can see, getting that twist
and that pressure is really important.
And that felt like we maybe had a little bit
of marginal ice in there.
It was mostly connected
and there was a bit of not as uniform
and then it connected again.
In those cases, oftentimes what I look for
is another place, maybe close by to place a second screw.
When placing ice screws, remember few key elements,
a good stance, uniform ice, get it flush to the face,
don't overdrive it and place between your shoulder
and your hip because it takes some energy behind that.
And have fun.
