Flappy solar ornaments have an interesting history.

Terrific Physics
40 followers
Flappy solar ornaments. These things are quite interesting because of their history
and what they owe their existence to. The circuitry has changed somewhat. It's been
very much mass-produced. The first ones of these were little flapping plants. I think they might
have even been called flip-flap and they were really expensive because they were sort of
designer gadgets at the time. But now they've been mass-produced to the point you often find
these in pound shops or dollar stores. So let's take a look inside this one and then talk about
the circuitry. Let's try that again. Take two because take one did not go very well at all.
I screwed that up so badly by just fluffing everything. So the thing is housed in a plastic
housing. It's got an outer trim. There's a common module inside. Most of these just have the same
common module that's used for multiple effects just for ease of manufacturing. And they have
this plastic trim and unfortunately this one they normally just push together but they'd actually
added glue to this one so it took unreasonable force to get this off. I had to take it through
to the kitchen and prized it with fierce knives and other implements to actually shatter it apart.
But once it's apart it is apart. I'll shove those bits of shattered plastic over there.
The base is composed of an upper section and a lower section and then a couple of trims on top.
The trims on top cover the pivots for the rocking mechanisms and lock them in place.
And one of the other covers covers the solar panel which is also I think it's a four cell
solar panel although oddly in this one I can't actually see the individual cells but it works
well. It might just be two. I'm not 100% sure there. It's usually four. Very hard to tell
looking at it. It's just not doing that thing where you look at them and they normally reflect
a number of lines. The unit has the two interconnected flappy wings, the leaves,
and if I hold this up like this one of them has a magnet. You can see the magnet there.
Let's zoom down on this. So you can see the magnet there passing above a coil that is just
literally glued to the base. It's an air cord coil just a purely a coil of very very thin wire.
The other flappy wing is just coupled onto it mechanically with a counterbalance. I can show
you that by lifting them out. So here's the one with the magnet and here's the one that just has
a plastic counterbalance and then this little pin here goes into this slot and just makes them
go up and down sync. The thing in the middle, the horrible bit in the middle with the flower
is just a plastic counterweight with a small metal screw just screwed into the middle and
I think it's just influenced by the fact there's a magnet swing in the vicinity and that basically
sets up a rocking motion. This is why it's kind of random. I don't know why they added that. I
suppose it was just for extra variety. When you pull this apart and the two top parts, it's a top
part that holds a solar panel and has a sort of pivot sections. Then let's get down close to this
and let's see if I can focus on that coil. I think that probably worked. We have the coil which I've
already broken the wires off because they're extremely thin plus this tiny little circuit
which has a blob chip on board. It's got the capacitor for storing the charge. What is the
value of that capacitor? It's 470 microfarad 10 volt and then it's got the little solar panel and
that's all there is which is interesting because the original circuits were actually fairly
sophisticated and it's where this build sort of owes its pedigree to. It's the original function
of these electronic pendulums that is interesting. It's much more interesting. I mean these are nice
ornaments but where they actually are derived from is very interesting. Let's take a look at
this coil. Let's take a much closer look at this coil because it's one of the hardest bits to make
It is literally just very fine wire that's been sandwiched between two layers. It's got some sort
of adhesive on it and then it's been wound and then the outer layers have been separated just
leaving the coil on its own that then has been glued into that recess and it's slightly off center
from the magnet for the reason that they actually it's part of the auto start feature that has to
kick it sideways instead of just deflecting it from underneath like the original systems.
So let's bring in the notepad and start doodling. So let's tame this image down a little bit. Let's
zoom up on the notepad. Let's focus on the notepad and lock off. Excellent. So in the past
you used to get these ornaments called kinetic art and they were very simple. They basically had
a coil that had a steel core down the middle and you've probably seen them. You can still
buy them online. You can definitely buy them on ebay from time to time. It's basically a base
with a little sort of stand and then you've got like a pivot there and various things like
three balls or various other items and one of them has a magnet underneath and it just swings
backwards and forwards and sometimes goes right over the top. The circuit for that was based on a
coil with a couple of lugs on it and a transistor just physically tacked onto that just basically
poked through plastic holes in the plastic and then soldered on and the circuit for that was
super simple. It was often nine volt that it was powered by and there'd be a transistor and I'm
transistor in a very odd orientation because it's connected to the positive rail instead of actually
pulling down to the negative rail but that's just the way this circuit was done and
there'd be a coil which would be tapped so that would be the zero volt rail of the nine volt battery
and there'd be a tap point with a fairly low number of windings switched by transistor but
then and this is how they can use this transistor reference to the positive rail instead of negative
there'd be another coil or a continuation of that coil that went back to the base of the transistor
and what would happen is this when the magnet passed this it would induce current in the coils
notably in this coil and when it did that the base of the transistor would be driven positive
with respect to its emitter and it would start turning on when it did turn on it would pull this
end of the coil positive and that would then induce further current in that coil and that would end
drive the transistor much harder and you'd end up with a situation that as soon as it's triggered by
a passing magnet it would turn this magnet on fully until it was fully saturated it couldn't
couple more current back and then it would turn back off again and when it did start turning off
this end would go negative and it shut off decisively so the net result of that was that
as the pendulum swung past it it would give it a hard kick however the one downside of this
very simple circuit is that you do have to start the pendulum swing you actually have to give it a
shove to start its swing and with these solar ornaments that doesn't happen so now we have
another circuit that was derived from clock pendulums and ultimately all these magnetic
circuits that kick pendulums were derived from clocks like the original kundo or kundo clocks
and other types that used early electronics or even electromechanics to make a clock that could
run off batteries so this circuit is different because it starts off with the solar panel which
i think is normally for panels but i suppose it doesn't really need to be and that has a capacitor
across it and the capacitor gradually stores the charge because the solar panel its own would not
be able to actually drive the coil that then goes across there there's the coil there's a transistor
which is actually built inside and this in this instance it could be npm is built inside that
little blob that pulls to the zero volt rail and which is effectively this is going to be plus
say two volts that's going to be zero volts 470 megafarad 10 volt the 10 volt is purely because
uh rate rating is purely because that's probably the lowest they could get in that style of capacitor
it's just an ordinary one it's not a low esr capacitor it's just a very very ordinary capacitor
so then you have and this is where it all gets a bit mysterious but you can find
circuit alternative circuits online here's the blob the question mark what's under that little blob of
resin here and this has a the transistor plus it's also got a sense pin effectively this one only has
three connections because the solar panel and the capacitor and the coil are all referenced to
one pad here the only other two pads are one for the solar panel and one for the other leg of the
coil and in this instance it has some clever functions when the sun comes out in the morning
and the solar panel starts producing a bit of current the voltage across this capacitor starts
rising and once it reaches a specific threshold determined inside this chip it fires this
transistor and that just gives the coil a pulse and you'll often see that in the morning that
these things will just start twitching but they won't go very far they'll just rock a bit but it
will twitch and then it'll sort of rock a bit and once it's gained enough momentum if there's enough
charge there the other feature this has got that it will charge up this capacitor but before it
reaches that threshold if it detects current being induced in this coil by the magnet passing
over it will use that to trigger it instead and that's when it becomes resonant and that's the
secret of these pendulums drawing so little current there it's a resonant circuit that just pulses the
magnet only when needed just very briefly just each time it passes from a specific position
very very interesting circuits so keywords for this are pendulum circuit
and if you like uh circuitry and mechanical stuff this could send you on a long journey on the
internet it's worth mentioning that it'd be nice i've tried lots of experiments this in the past
it'd be nice if you could just have a loop and a stem and a magnet in the end just swinging freely
in all directions and there are circuits that do that uh there was one called what was the name of
that again it was magic wood or something like that it was a wooden pendulum um it was a wooden
base a wooden stem that came up and then a pendulum that had a series of magnets placed
around randomly plus the kicker coil in the middle and it was one of those uh type of pendulums that
it just kicks randomly around all the magnets because it's finding a way through magnetic field
but every time it passed through the middle wildwood that's what it was called it would go
across that coil it would give a wee kick and it would just keep it doing that sort of random
jiggling about between the magnets sort of thing it's a very nice unit i bought one in america a
long time ago i still have it but not here unfortunately otherwise i would show you it
so i'll put a link a search link down in the description down below this is basically how
these pendulums work and if you look at the history you'll find that the kundokundo pendulum
was a early electric clock that had a big coil quite stylish and then a sort of curved
magnet that went through that and it actually actuated this the escapement mechanism it clicked
the second hand forward in the clock as it swung backwards and forwards but the first ones of those
were based on a magnetic physical electrical contact pulsing the coil as it passed on each
swing in one particular direction but laterally they did incorporate very early transistors maybe
even a capacitor to stop sort of oscillating at a resonant frequency but if you search online for
the pendulum circuit schematics you'll find all sorts of circuits including the version for the
clocks that has the extra transistors and basically shows what was in this blob before
they switched to using the blob and hiding the secrets of what's inside purely for mass production
very interesting circuit and you know this circuit on its own this little tiny circuit board
has other uses you could make your own pendulum system with it it's very neat so i shall let you
explore the internet now that i've introduced you to what's actually behind these little
cheapy ornaments that you can get from pound stores or dollar stores for one dollar one pound
they're so mass-produced now their heritage is much more interesting than these little products
themselves
