FUEL 415 Crossbow Assembly

Exploring Ancient Crossbows
3 followers
7 Video Views·Jun 20, 2025
FUEL 415 Crossbow Assembly
In this video we're going to be covering general assembly. So getting started,
make sure you unpack everything inside your box and make sure that you have all the parts
that are included in the instruction manual. For tools you're going to need a flathead screwdriver,
an eighth inch allen wrench, and a 3 16th allen wrench. Both of these will become included inside
the box. You have your front end, you have your barrel, your back end, your cable slide,
rail lube, your foot stirrup, your riser bolt, and your scope. So getting going first what we're
going to do is we're going to locate your front end and the cable slide. The cable slide is
designed to go on top of the cables in between the cables and the bottom of the barrel. This
helps improve wear. The cable slide has two slots on the bottom that both cables run through. Next
step is we're going to install the cable slide onto the cables. You're going to align the two
cables with the two slots on the bottom of the slide. Sometimes what we like to do is put a
little bit of rail lube on both slots and also the main slot on top. This just helps with cable wear
as you shoot it. Take the slots, align it with the cables, and you'll notice that it crosses,
the cross is just to the left of your slide. From here, take the barrel,
take your cable slide, the string on top of the barrel, and slide it into a slot.
Pull the riser toward you, aligning the barrel nut with the hole in the back of the riser.
With the riser attached, we're going to locate your riser bolt and your 316 Allen wrench.
We're going to install the riser bolt from here. Next, we're going to install
the foot stirrup. These two Allen wrench screws are designed to fit in the slot on the bottom of
the foot stirrup. Install the foot stirrup with the slots facing up. Take your eighth inch Allen
wrench and snug these Allen screws down firmly. The center Allen wrench screw is designed to lock
into the riser bolt, and that just adds an added level of protection so your riser bolt doesn't
come loose. Next, we're going to install your scope. Sometimes out of the box, your scope
will need the scope rings adjusted. It does come with a three millimeter Allen wrench
where you can adjust your scope rings back and forth. Notice I remove the nut and the plate
before I try fitting it to the rail. Now, a good rule of thumb is to make sure that you start the
eyepiece right at the back of the trigger box. But no, you can move the scope forward or backwards
depending on the amount of eye relief that you want. Here, the little plate. Notice when you look
at the side of the plate, there's a thicker end and a thinner end. The thicker end goes up after
the plates are on. You add the scope ring nuts. Just snug these up finger tight, and then take
your flathead screwdriver and tighten them down from there. If you have any additional questions,
please contact your customer service for help or visit KillerInstinctCrossbows.com. Thank you.
