2x4 Workbench

Sparky Deal
160 followers
Made from 2x4s and one sheet of plywood
Massca Pockethole jig
https://masscaproducts.com/?aff=30
#DIY #howto #woodstuff
All right in this video I'm going to show you how I made this workbench
slash outfeed table for my table saw. So the first thing I did was I set up a
stop on my miter saw and I cut all of my
vertical pieces to the same length. I'm going to end up using
six vertical pieces and six horizontal pieces
and they're all going to be attached using pocket holes.
In here I'm using the Maska pocket hole jig.
All right next I'm going to get my horizontal pieces set up here.
In here I'm cutting these to 48 inches which is the width of the plywood that
I'm using.
And then you see here just attaching it only using pocket holes
and I believe those are two and a half inch screws.
All right so I'll basically be assembling three of these rectangles.
All right I'm going to space them out to 24 inches
and then here I'm going to attach my spacers also using pocket holes.
So the assembly of this entire table will be done with pocket holes.
To make the frame for this whole workbench it only took me five
two by fours. All right and so what I did was
once I had the frame together I just set the whole sheet of plywood on top of it
and cut it to the length that I wanted. Here I'm using my Makita track saw to do
that it's very easy. And there you have it a workbench
outfeed table using just two by fours and a sheet of
melamine plywood. All for about a hundred bucks.
