Crystal and Glass Laser effect.

Terrific Physics
40 followers
Well hi, Tom Altman here. As a result of popular demand, I've put together some more laser effects.
This is an old one that I've done for quite a while. It's a simple laser module. It runs
at about 3 volts DC. It's a green module. It costs about $25 from dealextreme.com.
And there's a rotating crystal. The crystal is located slightly off axis, so it's got a little
bit of a wobble, but it produces a better effect. And I have that crystal attached to a slow turn
motor. I get slow turn motors from American Science and Surplus. And there's a couple of
them that they have for the $10 to $25 range. Also works on 3.5 volts. So I've got both of
these attached to a simple transformer. They both come from the same line. They're wired up in
parallel. And one goes to the laser, one goes to the motor. So it's a very simple unit to put
together. And when the laser goes through the crystal, it produces a beam on a wall,
which is kind of cool to look at. Obviously, the dots are kind of fun. They move around.
Because the crystal is off axis, you get a little bit more action with the dots. They're
kind of cool. Well, I've been doing this for quite a while. This is a very common effect.
Obviously, with smoke in the air, you would get to see the beams coming at you, and that's even
cooler. So this is kind of fun. It works as a beam effect with smoke in the air, and it also
works as a pattern effect. You shoot it on the wall, and you get that effect. It's very common.
I put a red one up there, and I can have Christmas effects. The red crystal is turning considerably
slower, and so the pattern changes at a different rate. Obviously, if you change the voltage to that
little motor, you could change the speed at which it turns, and subsequently the pattern.
But for this thing, I just plugged it straight into the laser. It's three volts. Stuck with that.
Now, I created this variation for a very specific reason. I had just gone to a glass shop for doing
glass molding. This is a place where you get pieces of glass, and you melt them together.
I had some iridescent glass, and I kind of had this in mind. Some iridescent, a little bit of blue,
iridescent. Then I'm going to shine my laser through this. Now the beams of light are coming
through, and they're going to strike and produce a different kind of pattern. That's the kind of
thing I was going for, that different pattern. It's pretty cool. I like it. So a simple laser,
a spinning crystal, and then some kind of a pebbled glass, or a glass with some kind of
surface that distorts light as it goes through it,
and it produces this stunning effect. Pretty sweet, huh? Merry Christmas!
