Blade Replacement on Makita SP6000J 6-1/2-Inch Track Saw

Sparky Deal
161 followers
I absolutely love this track saw. I have been using it for over 2 years now and it's been nothing but amazing. I highly recommend getting a track saw for your woodshop. there are alot of very reasonably priced option on the market now.
I know a few people who have used the WEN track saw with great results.
WEN Tracksaw
https://amzn.to/3VAAuB9
This is everything I use with my tracksaw
Track Saw
https://amzn.to/3Im3uJQ
Blade
https://amzn.to/3juZV9W
Tracks
https://amzn.to/3Ic85ye
Clamps
https://amzn.to/3WDXlgK
#DIY #howto #woodstuff
Alright, today I'm going to be changing out the blade of my Makita Treksaw.
Alright, so you're going to have one, two, three, four, five Phillips head screws that you're going to need to take out.
And then this plate will come off, so the dust port, just set those aside.
I always try to keep my screws somewhere where I won't lose them.
Then you have your Allen wrench here and your handle.
Then up here you're going to have this button here.
This is going to lock the Allen wrench so you can loosen it.
So you push that down and then loosen, and I was already in here so that's why mine's really loose already.
Set your screw in your piece with all your other stuff.
Old blade comes out.
I really like this blade so I got the same one again.
I've had this Treksaw for a while.
I probably should have replaced my blade already, but it has been working great.
So I just went with the same one because it's worked great for a couple of years now.
So I'm going to take the old one and get it sharpened, and then that way I have my backup so I can switch them out whenever I need to get them sharpened.
Be careful, it's very sharp.
Get that on there.
Then the same thing again.
You're going to push down on this.
Use your Allen wrench to tighten it.
Everyone always says don't over-tighten your saw blades.
I'm always a little worried I'm not tightening it enough, but so far I haven't had any issues.
Then we will take our dust port, set it in there.
Set that in place.
Hand turn a couple of them just to make sure that it's in place.
Alright, and that's all there is to it to changing out your Treksaw blade on your Makita Treksaw.
I will link the blade below that I am using.
It's just the stock blade that comes with it.
Thanks for watching.
