WET Didgeridoo - Building PVC Multi Drone part 2

Learning Didgeridoo
4 followers
#Education #music # instruments # Traditional Australian instruments #Didgeridoo
Ok, so now we're going to shape the PVC sections in a way that's going to enable you to play
the multi-drone, and pretty much you just want a long bell section on it.
So we're going to have a really small top end, and that's going to give you a lot of
back pressure.
So you're going to put the mouthpiece we just made onto the really small top end, and then
you want to try to step up to something bigger pretty quickly.
So we're going to step up to a pretty fat pipe right away, and we're going to keep that
one kind of short too, not too long.
This is an inch and a half, and immediately step up again, again making it short, and
then we're going to step up to a really long bell section, and this long bell section is
going to lower the first trumpet to be really close to the drone note, and that's what's
going to be able to enable you to hit the octave below the first trumpet, which is going
to give you about four drone notes to play.
So that's generally what it's going to look like for the multi-drone technique, and you
can play around with any shape, any length.
This one's going to be a little bit high, and if I were to make this section even longer,
or put another extension to go up to a bigger pipe, you could probably get that first trumpet
to be really, really low, which is going to give you a lot more flexibility control in
between the normal drone and the drop octave drone.
You're going to have a lot more frequencies that you can sit on.
