Upgrading My Park Roller Skates! NEW Bont Setup + Pro Tips

How to Roller Skate
2 followers
Hey everyone, Shorty here.
Today I'm giving my park skates a much needed upgrade.
So now I've got the stock vegan black park stars with an oversized plate.
This plate is the next size up from what should be on my boot.
This gives me extra front to back stability.
If you're walking park stars and want to add a bont slide block,
check your tracer plate size.
You'll find the size near the rear pivot cup in inches.
In the box you'll get four 10mm barrel cushions.
These will replace the current cushions in your plate.
Alright, let's install these blocks.
So first you want to take off your kingpin nut, your cone cushion cup,
your cone cushion, your truck, your barrel cushion and your barrel cushion cup.
Slide on your new blocks and then put the barrel cushion cup
and the new 10mm barrel cushions on.
So I'm a huge fan of these blocks as the edges are designed
so you can angle your feet while sliding and still feel super stable.
If you're using your stock trucks, put them back on
but if you're upgrading to the bont grind truck, grab those and add them instead.
Now put back your cone cushion, your cone cushion cup and then your kingpin lock nut.
Before you tighten everything up, make sure your block is centered.
I like to tighten the nuts a bit, then double check the block
and then finish tightening just to make sure that I have it centered.
Time for wheels.
I've been using the bont full flight park wheels which have a 101 hardness
and a 53mm high and rounded edges.
These are perfect for technical trick skating
but on this setup, I'm going to be switching back to the bont park flows
which are 98 hardness and 58mm high.
This is because I'll be doing some boat skating over the next few months
and taller wheels means more speed for less effort.
Let's get these wheels on.
If you swap bearings in wheels a lot or have metal hub wheels,
a bearing press is the easiest way to install bearings.
So the bont bearing press I have here works with both 8mm and 7mm bearings
which I use 7mm in my derby skates
and you just need to switch out the pole which is included in the box.
If you're new to skating, then you want to check the tightness of your wheel nuts.
If your nuts are too loose, your wheels will wobble and you might slip.
So tighten them a few turns, check the spacing and repeat until there's no play.
Then give your wheels a spin.
If it's too slow, you may have over tightened them
so just back it off a little bit.
Wheels on and you're done.
Now here are two tips for my fellow park style skaters.
If you always bail to the same side like me,
then the side of your skate takes a beating
and the d-ring where your strap attaches can wear down.
To protect it, adjust your strap to cover that area.
I wore down my strap so much it started eating up the d-ring
so I should have replaced it sooner.
Tip two, landing big jumps can be tough on a metal plate and fiberglass boot
so I swap out my bont insoles for an impact insole for extra cushioning.
All right, now it's time to take these beauties for a spin.
Thanks for watching and don't forget to subscribe to my channel
for more skating tips and tricks.
you
