Gun Restoration | Colt Model 1903 Pocket Hammer, (with test fire)! #restoration #restore

Gun Z9
3 followers
11 Video Views·Dec 25, 2024
Here is the Colt Model 1903 Pocket Hammer, which is based off of the Colt 1902 Sporting Model,
which is the turn-of-the-civilian-market variant of the Colt 1900 Sight Safety.
This model is also missing a slide stop.
The Colt 1902 Sporting and Military Models had a slide stop, also along with the Colt Model 1905,
the first modern Colt handgun chambered in .45 ACP.
But without the slide stop, it makes this firearm ambidextrous,
meaning that it can be used by left-handed or right-handed persons.
So of course, like most of my restorations, I always like to take grips off,
and then proceed with getting the magazine out to make sure that there are no cartridges left in the firearm whatsoever.
The cartridges left in the magazine do not appear to be that old.
Maybe 10 years, maybe 15.
There's no way to tell.
Sometimes the amount of cartridges left in the magazine is a little more than that.
But they're definitely not from way back in the 1920s or 30s or anything like that.
So we will just put them off to the side and move on.
Most all magazine disassemblies are pretty similar.
You have to depress the magazine follower about halfway down the length of the magazine,
and then put a pin or something small to fit through the hole to hold the magazine spring in that place,
and then get the follower to come up to the top of the magazine.
The magazine is resistant, and it should come out fairly easily.
But some other magazines do have a feature on the bottom of the magazine
that you can take it apart that way, which is easier than this magazine.
I did suspect that the firing pin would be broke,
because this happened a lot with these firearms,
because the firing pins were made out of bronze and beryllium copper,
a little bit more of a softer metal that tended to break.
This is the backrest that I'm putting into this container.
I'm going to take all the parts, soak them overnight before glass bead blasting,
that way my glass bead can last a little bit longer,
because it is not taking out so much rust and gunk off the pieces at one time,
preserving the glass bead a little bit longer.
So we will skip ahead right to glass beading now.
As you can see on this part of the slide,
the roll marks are quite faint on the back end.
Until you get through the patented mark, it will grow a bit better,
and you can also still see the random cold.
And on the opposite side of the slide is the worst part.
This must have been laying on something wet or moist for some time,
because hitting is very bad on this side.
And the beryl is sort of hitting evenly on both sides all around.
And as for the bore, it looks pretty much shot out.
And it's all gone.
The rifling lines are still present,
but it looks pretty much through with some frosty hitting.
I'll just one-hand it.
Good?
You just got jammed.
Please stand by.
Let's see if we can hit anything with no rifling.
I had one more.
I had a fly bite in my dang ankle.
That's why I stopped for a second.
You love them sweet ankles.
So, it's probably time for a penetration test with the ballistic gel.
I had the clear one in the back.
I guess it's going to make it through this.
Caught them both.
Backwards, just like the last time.
There you have it.
Colt 1903 pocket hammer.
