Fall Hanger DIY || Fall Decor || Just 1 Quick Craft

Holiday Decorations
97 followers
Hey everybody, it's Beth. Today I'm using this long wood hanger that I got from Dollar Tree.
I'm brushing on Antique Wax by Waverly and then I'm taking a baby wipe and blending it all in,
smoothing it out, and I do this to the entire board. Next, I am taking these pumpkins and
scrapbook paper I got from Hobby Lobby, tracing out the pumpkins and cutting those out and setting
them aside. I then paint the edges of each of the pumpkins with Buttered Pecan Acrylic Paint by
FolkArt and I take that same color mixed with Truffle Chalk Paint by Waverly and brush that
on each of the stems. After those are dry, I take Mod Podge and brush on a layer of that
on the front of the pumpkins. I don't cover the stem with the Mod Podge, just the pumpkin.
Place down the scrapbook paper and smooth it out with my hands. I do that to all four and make sure
that layer is completely dry and then add a layer of Mod Podge on top of the paper.
Next, I go around with my micro sander and sand off any excess paper. I then take these two-inch
wooden letters that I got from Amazon and paint them with Toasted Terracotta Acrylic Paint
and that is also by FolkArt. I then am taking each letter and hot gluing one of them to each
the pumpkins. I then place them on my wood hanger, getting them more towards the bottom
because I'll be making a bow for the top. Once I get my placement how I want it, I hot glue
each of them into place. Next, I'm making a bow. I'm just taking different ribbons and I'm pinching
the center of the ribbon, holding it in my hands and then crisscrossing the different patterns
like an X in my hands. You can use wired ribbon, non-wired ribbon, either works fine.
Some of the ribbons are one and a half, others were two and a half inches and I cut them in half.
I like to use at least four different patterns and I fill it all in and then wrap the twine
around the center where I had been holding it nice and tight. Cut off the excess and then I
go around trimming up any of the ribbon that is a little bit too long. I pull apart the ribbons
and kind of pull them forward and then hot glue that to the top of my hanger and then take the
twine hanger that was originally on the board and put that back in and that is it for this project.
Thank you so much for watching!
