Making the 300 Spartan Helmet (King Leonidas)

Forging the Past
1 follower
1 Video View·Nov 30, 2024
In this video, I am showing how I made the king Leonidas helmet from the movie 300.the footage of me making the mow hawk/crest was lost so sorry it is not shown in the video.
Hi, I'm Robert from Gold Point Props.
For this video, I'll be showing you how I made the King Leonidas' helmet from the movie
300.
I first started with my hand drawing pattern and marked out the faceplate on 18 gauge sheet
metal.
Using tin snips, I cut out both sides of the faceplate.
Using the roughness of the cement brick, I added a texture to the metal.
I'm now using a pointed hammer to add pitting around the edges.
Here I'm feeding it through the roller to give it the curve I needed.
Then I used a hammer and anvil to flare the peak.
Now that I have both sides shaped and formed, I welded the two halves together.
After welding it, I ground the weld smooth, but being careful not to remove all imperfections
so it can match the texture I did earlier.
Using all the previous processes shown, I formed the back of the helmet.
Here, I'm marking out both sides of the dome piece.
Then I used a stump with a slight dish in it to hammer out the pieces.
Normally I would use an English wheel to smooth out the hammer marks, but this helmet has
more of a rough look so I left them.
Next, I marked out the side of the helmet onto the dome piece.
Then using a pair of pliers, I added a flange.
Now I'm using the pointed hammer to add the texture and pitting to both sides of the dome piece.
Then I welded all three pieces together.
Now I'm moving on to the back flange of the helmet.
After attaching the back flange, I then welded up all the seams of the helmet.
Now to move on to the base of the mohawk.
I used a pair of pliers and a hammer to fold the metal over to give it a more thicker look.
Then I repeated the process to all the pieces that make up the mohawk base.
Once that was done, then I welded all four pieces together.
Now I'm attaching the mohawk base to the helmet.
Now that the fabrication is done, I used a Dremel with the cut off wheel and added the
battle damage.
Now I'm moving on to the final step, brass plating the helmet.
I'm doing so with a hand held torch and a brass wire brush.
I heat the metal until it turns blue, hot enough to melt the brass onto the steel while
I brush the brass across the surface.
Now that the brass plating is done, the helmet is finished.
