Inside The Cockpit - VAK 191B (V/STOL)

Military Fighter Aircraft
1 follower
I want to give special thanks to my Patreon and channel supporters that make these videos
possible. It's them that provide the funds for me to travel to museums and without them,
this content would not exist. If you are not a German native speaker and at the conclusion of
this video are able to pronounce the full name of this aircraft, well, then you deserve a medal.
Hello everyone and welcome back to Military Aviation History. I'm your host Bismarck
and this is the VFW VAK-191. VFW stands for Vereinigte Flugtechnische Werke,
a post-World War II West German conglomerate of Focke-Wulf and Weser Flugzeugbau GmbH,
temporarily also joined by the Dutch WACKER company. Now VAK stands for Vertikalstartendes
Aufklärungs- und Kampfflugzeug, which incidentally also explains the role of this aircraft in one
compact three-letter designation. Welcome to Germany.
Now the aircraft itself is operated by a single pilot. It's 16.4m in length,
has a wingspan of 6.2m and a height of 4.3m. Empty it weighs about 5,500kg and goes all the
way to 7,800kg for maximum VTOL take-off and 9,000kg for maximum short take-off. It's an
experimental VTOL aircraft with the name translating to Vertical Take-off Reconnaissance
and Strike Aircraft. Thus, it's the German entry into an exciting chapter in aviation history.
There are only about two on display at the moment, both in Germany, so let's have a closer
look at this one found at the Flugwaffe in Schleisheim next to Munich. The aircraft has
three engines, one Rolls-Royce MAN Turbo RB193 and two Rolls-Royce RB162 turbojets.
The single RB193 with 10,000 pounds of force was located in the middle of the aircraft,
providing thrust along four rotating nozzles for vertical lift and for cruise. The nozzle range of
motion is about 95 degrees and it was also this engine that was used for flight. Two RB162s with
5,600 pounds of thrust each were situated fore and aft of the former engine, providing extra
power for vertical lift. Mounted internally, they were counted aft at 12.5 degrees from the vertical
and when not in use, they were covered by retractable doors. The lower door on the
forward engine doubled as an airbrake. To prevent the aircraft from somersaulting in case of failure
in one of them, they were coupled. The aircraft also had a maximum speed of about 1,100 kilometers
per hour, but the range of the aircraft isn't that great, with an internal fuel load of around
about 2,100 liters. The range sits at only about 400 kilometers, although as a prototype,
this would have certainly changed with time as development went on and different loadouts were
being proposed. Then again, for the WAC, range really wasn't that high of a priority.
The aircraft followed NATO's requirement NBMR3, which called for a strike aircraft as a spiritual
successor to the FIA G91. The aircraft's role was meant to follow essentially the same logic.
You take off at a short distance from your actual target, you close at high speeds and then you blow
stuff up. In fact, the earliest plans with this aircraft was that it would drop nukes, small,
little, 2,000 pound nukes perhaps, but nukes nonetheless.
So let's have a walk around on the WAC 191. Up front here, this area houses a lot of the
electrical equipment, the flight computing and so on. TACAN is also in here. And as we move along,
you can obviously see the maintenance hatches here on either side for quick access. Then we have the
pitot-static tube and as we move along, we can see the rear hinged clamshell canopy for the pilot.
Then we have the air inlet for the RB193. That's the big engine in the aircraft. And then down here,
we see these little doors. Those are for the RB162s. There's also two more doors on top of
the aircraft. As you can see, these open forward and aft, whereas on top, they open to port and
starboard. The front one is also doubling as an airbrake here, but this is the only flap on the
bottom of the aircraft that doubles as an airbrake. As we move along a little bit further, one thing I
would also like you to check is the gear. Now we have one gear wheel up front, which is somewhat
of standard. You would say in a tricycle landing gear configuration, but the aircraft isn't a
tricycle. More on that later. As we move along, we come to the rotating nozzles of the RB193,
the big engine. And these can of course be swung depending on what you need for your vertical
takeoff and landing, towards cruise position essentially, towards the landing and takeoff
position. And there are two on either side for the engine. And below that, actually right below
the engine, you will also find the bomb bay for your ordnance. As we look further on, we have of
course the wing. But before we do that, let's have a look there. And there you can find the gear of
the rear gear of the aircraft. And it is in fact a bicycle configuration. Fair enough, it's a twin
wheel at the back. But that puzzle will be solved soon, because a bicycle gear configuration will
probably be a little bit unstable in an aircraft. But we have of course an answer to that. 48
degrees sweep on the aircraft here on the wing. The wing loading of the aircraft is actually quite
high, roughly 610 kilograms per square meters. And here we have the outriggers. These actually
provide the stability and the ability for the aircraft to land and take off. You have the same
thing on the Harrier, right? So small gears set on either side. You have one other on the
port side as well. And they of course fit into this tear-shaped outrigger that we have here. Also
on either side of the wings, we have air bleed puffer systems that provide that thrust on either
side in order for the aircraft to maintain stability as it is taking off and landing. Now,
moving further towards the rear, we of course find the aileron and the flap of the aircraft.
And moving on further, we have another electronics panel right here. And we have the all-moving
tailplane here with the vertical stabilizer and of course the rudder. Up top would be your antenna
also for the radio and the IFF system if it was ever fitted. And then last but not least,
we come to the back. We have another puffer system there as well. And of course,
we have a drag chute added to the aircraft as well. As a recon and strike aircraft,
the weaponry will naturally center around explosive stuff. Below the fuselage,
there is a dedicated space for a 2,000-pound nuclear weapon. Given that the nuclear strike
role was one of the core of the designs, its very reason to exist really, there wasn't much else
planned at the beginning. You could probably have added some extra ordnance on the wings,
but given the lack of space, it would probably be only a single hardpoint really that is the
limit on the present wing configuration. Later on, on a redesign, it actually envisioned two
hardpoints per wing as the wing was lengthened, but the project stayed on paper at that point.
No decision had yet to be made on the cannon armament, but it would probably
have been some sort of Mauser considering that it's a German aircraft.
So we're on the port side of the aircraft. Just up front as well, we have antennas for the radio.
And then this is most likely the area where a cannon would have been fitted if the aircraft
was ever pushed forward into mass production. However, since that didn't happen, we can only
speculate. We also have the RB-162 engine here. As you can see, there's a nice little cutaway
to give you a look at the engine that is fitted fore and aft of the RB-193, which gives the main
thrust of the aircraft. And this engine would also be used, for example, in the Dornier Do 31.
Let's have a look inside the cockpit. It couldn't be opened, so an outside view has to suffice for
today. Sadly, there is very little information available on the WAC-191's cockpit. In fact,
I haven't found a single reference with any real detail on this. So I go into this blind,
but it's not too hard figuring out the basics if you are familiar with the systems of the time.
Given the lack of info on this cockpit, it's rather exciting getting this on film.
We of course have the ejection seat here. That's a Martin Baker. I believe it was a Mark IX,
in fact. Next to it, what looks like a mountain jig. This might have been used to house a camera
or equipment during flight testing. Looking inside, it was hard to spot any instrument
with the naked eye, let alone the camera. I'll keep this restricted to the left instrument panel,
as this was the only one we were able to capture in any detail, but luckily it's also the most
interesting part. Starting closest to the pilot, the communications panel for the UHF. Above it,
or rather to the right from our view here, the fuel systems control panel with the low-pressure
fuel cogs. Above that, the grey lever is for the main high-pressure fuel cog, currently is set to
closed. To the left, the trim control. From top to bottom, we have roll, pitch and yaw. Next to it,
most likely the stability control switches. Then we move on to the throttle. This one might
be familiar to you, it's the same one seen on many aircraft of the time, like the Fiat G91
or the F-104 Starfighter. This one operates the main RB193 engine. The throttle has a speedbrake
switch and press-to-transmit button. As you can see, there are actually two rails here,
and out of view must be the lift engine control lever for the two RB162s. To the outside of the
throttle, the flaps. And moving to the inside, the nozzle angle selector and the preset stop.
These are of course for the main RB193 engine, and would be used to turn the nozzles for retoll,
take-off and landing. Due to the reflection, not much can be identified throughout the cockpit,
but maybe in the future I can return it to Flugwerft and have a close look in a better
light condition. And at that point, I'll of course bring it to the channel as well.
The VAC-191 got off the ground, but it never really went far. Development began in 1961,
and in 1963 the VAC had secured NATO's go-ahead versus the competition. Ironically,
one of the competitors was actually the British Hawker P.1127, which eventually
led into the Harrier as Britain dropped out of the NATO program. In 1967, feared from Italy,
the only other NATO co-developer with the aircraft left the program as well. NATO too
decided that a policy of massive nuclear retaliation was a bit harsh and wanted a
flexible conventional solution. The VAC simply couldn't do that. Its design was one of high-speed
one-pass nuclear strike. A second concept was drawn up, which extended the wings and operated
the engine to allow more conventional payloads, but that was a fool's errand in the end.
There was nothing really that could save this aircraft. Development however was continued into
the 1970s as a testbed and as a proof of concept. By 1970, the first aircraft had also been put
together and a first flight was conducted in 71. A first successful VTOL take-off followed a year
later. Germany then invited the US to join development once more, but by this point the
multi-role combat aircraft MRCA program was already underway. So again, nothing. But hey,
MRCA eventually let into the Panavia tornado, so we got that flexible machine after all.
here on YouTube. If you can't do that, don't worry, I understand. There are many ways of
supporting the channel as well, for example by simply sharing this video with your friends
and on the internet. Please consider subscribing and hitting that bell button so you will get
notifications for upcoming videos. And as always, have a great day and see you in the sky.
