Carving a Wood and Epoxy Paddle / Board with Just a Dremel

Nghệ thuật chạm khắc gỗ
6 followers
Hello, I'm filming a simple project today where we're going to be making a
paddle of Greek life. So here I have a quarter inch thick board of walnut as well as a quarter
inch thick board of poplar. The rough idea which I'll be doing is using a Dremel 4300
to take out these red lines of negative space as well as these letters and numbers
and then once this is cut out I'll be laying it on top of the poplar board so that you see
the lighter wood underneath. So we'll start out with scoring these letters that I taped on. I
didn't want to do it freehand so I just taped them with a tile cutting bit and then removing
this tape getting it cleaned up and then cutting out the rough outline. I did kind of
mess up there but you know I sanded it out. I broke it, it's no big deal. I'm going to
go towards this back end and instill these little fibers that are kind of hanging off. I really want
to get rid of those and sand off the middle of it as much as I can prior to gluing it because
once I glue it to this back board there's really not going to be any way to sand inside of there
without also sanding the board the poplar in the back and I really don't want to do that.
I want to keep this nice and smooth. Then once I'm done with that I'm going to glue it up super glue.
I glued the large piece right up to the end. I failed to realize that the smaller piece
goes a bit further. This is very well glued. The only thing I can think of
is I'm going to slice a strip off of here, use the straight edge, glue it to this side,
really hope it lines up and then be able to glue the smaller piece. I'm going to hop in with
just a regular cutting burr like this one and align these and then also I'm going to
round the edges. I've decided that it looks a bit plain right. I don't want to really just sand it
off and be done and I did want to try something new so I decided oh it'd be cool to try epoxy
right so I went out and bought some and then I mixed it with the chalk powder that I crushed
last night and here's it in the different concentrations. I think I'm going to start
with a blue base inside of here, a darker blue and then the lighter on top. I've also added
these pencil lines as you can see to give it even more texture. I'm going to go in and
cut a line around this outline and then add a circular texture between.
I've taped off these edges because it's open. I'm going to mix two batches of this epoxy.
One of them is going to be lighter, the other darker. The darker is going to be the base.
Don't mess this up. We'll start with the darker one. It looks like this is clumped a bit overnight
from the moisture. I'm already going to dump some of that out, that's too much.
All right, this is a good old mixing. Okay, it starts with not too much.
That's too much.
Now a very light sprinkle.
I'm happy with this color. Here we are. Let's get pouring.
All right, it's dried overnight. It seems pretty well cured. I want to get all the epoxy off of the
wood on the outside here. I'll go in with a sanding disc just to flatten it off and then
I'm going to sand the entire thing front and back so that it's ready to get oiled.
I sanded it up to a thousand grit. I think I'm content with how it is. I think I'm all done.
I'm going to take it inside and finish it. Take oil it is today.
I'm just going to put a very little amount on here.
I have a lot. Here we are with the final product. It's quite the process,
but I think it came out pretty well. It's really smooth. This is still fairly clear after sanding
it. If you like this, I've got a couple more videos coming out soon. Stay tuned and thank
you for watching.
