How To Use Sewing Awl On Leather

DIY Crafts & Art
164 followers
What up fam! Today we learn how to use this stitching awl on leather. Stay tuned. I got
this sewing awl from Tandy Leather and it is my new favorite tool. Let's check it out.
So it consists of a needle, a chuck to hold it, a bobbin for your thread, and a hollow handle
for storage. Opening the handle, we can see that it comes with a tool for the awl, as well as a
good amount of needles. Oh, and the needles themselves are actually special. They have
this little groove for the thread to be able to run through that ends in the eye, which is just
below the point. Okay, so to remove this bobbin, all we have to do is take off the screw holding
it in place with the provided tool. Now you can switch it out for other colors or refill as needed
or whatever. Alright, so to get ready to sew, just pass the thread through the chuck at the top.
Then put the bobbin back in place and secure it with that keeper screw.
Next, I pull the thread to one side and insert the needle, being sure that that groove lines up with
where the thread's coming out. Now just pass the thread through the eye of the needle. Just make
sure it's on the side of the needle that has the groove. Finally, just tighten everything in place
with the provided tool. At this point, we're ready to start sewing. Okay, so start by pushing the awl
through your first stitch hole and then pull it back, leaving a loop. Now just pull the tail of
thread all the rest of the way through. You're going to want this tail to be a few inches longer
than the entire area you're trying to stitch. Okay, so after pulling that to length, drive your awl
through the next hole. When you pull it back, you can see this small loop of thread is left behind.
Take your tail end and pass it through that loop. Then just pull both sides tight to form a secure
lock stitch. Now simply repeat this process all the way down the line, forming little loops and
passing the tail through those loops to lock into place. With practice, you can actually get to be
really fast with this. Okay, so when you reach the end, simply backstitch a couple of holes to finish
everything off. Then cut away the excess thread and melt the ends. This leaves a nice-looking,
super clean, strong stitch. I love this tool. Let me know if you give it a try and what you think.
In the meantime, though, keep leveling up, you.
