18th Century Dial Clock Restoration - FINAL TOUCHES - Weeks of Work Part 5

Legacy Conservatory
14 followers
#antique In Part 5 of the restoration of a lovely Verge dial clock by Weeks of London, I regulate the restored movement, clean and repair the dial and hands and complete the final assembly.
The clock now ticking away on test, I can turn my attention to repairing the minute
hand.
You can see it's had, this is actually a bit of another hand I think, that's been brazed
on to a broken original section.
The hands are the correct style and a match for each other, it's just that tip that's
wrong.
So, first thing I'm going to do is to scrape all of this black paint off and see what we've
got underneath to work with.
There we go, that's what's underneath the black paint, I've just scraped it off and
that's a pretty original hand that will just need a bit of a light clean up and re-bluing.
This one is the one that we've got to work on which is again pretty original, it's actually
soft solder and I will heat that up, get rid of it and see what we've got to work with.
Here are the hands in style, here's what we're left with now that we've taken the old
piece off.
As you can see it's a fairly simple job, I've just got to make up a new tip like that but
smaller and I'll hard solder it on with a sort of a lap so that hopefully the joint
is not going to be particularly visible after the hand is blued.
So, that's the next job and I'll come back when I've got that tip soldered on.
Here's the repaired hand, I've hard soldered a tip onto it with a sort of a splice so that
the joints overlap so hopefully there will only be a very small little slither of solder
visible when the hand is blued and the style is appropriate to the other hand and the length
also correct for the minute track for the hand.
So, I'll blue those hands and that will be that part of the job complete.
The dial is in very good condition, it's been polished back with some Brasso at some stage
so none of the original silvering is present but the ageing is actually very nice, I'm
going to try and retain as much of it as possible.
The waxing is not in bad condition, it's starting to break up a little bit but I don't want
to re-wax the whole dial so I'm going to try and localise the repairs.
This is the worst bit here in the number 12 so I'm going to try and just drop a little
bit of a little sort of chip of wax into there and then I'm going to give it a light clean
and re-silver it and see how it looks.
You can see looking at the back of the dial the evidence of the Brasso as it's crept around
the back of the dial.
There's fundamentally a lovely colour at the back of the dial, I'm going to just try and
retain that as much as I can.
There's the completed dial, I have washed, cleaned and waxed the back side to get rid
of the Brasso residue and loose dirt and things and to protect it for the future.
At the front I've repaired the losses in the wax, in the numerals and I've given it a light
clean and then silvered and neutralised and then waxed with Renaissance wax.
Just turning up a nice little collet for the hands, one of the last jobs.
Just before the movement goes back in its case I'm just getting the timekeeping somewhere
near.
I've made the pendulum rod slightly too long so I do have to just trim the end of that
rod off a little bit but I'm just tuning it in to its target rate at the moment so when
I get it to its target rate I will just trim off that bottom of the pendulum rod and put
the movement back onto its dial and into the case.
Here's the completed movement and dial ready to go back into the case.
Thanks for watching.
