CMOS OP AMPS- Two Stage Operational Amplifiers-EC462 MSCD
#ktu #s8ece #mscd
This video explains block diagram of general two stage op-amp, compensation of OpAmps & Small signal dynamics of two stage OpAmps.
For full class:
https://www.youtube.com/playlist?list=PL2UV2EJdMQmim5UHGAuX6HtsAVCRB-2Ix
Hi all, today we are starting our third module.
In this third module, we are going to learn two topics, CMOS OPAMP and CABRIATISM.
Today we are discussing, we are starting CMOS OPAMPS.
CMOS OPAMP is a two-stage OPAMP.
The two-stage OPAMP will be used to introduce the important concept of compensation.
The two-stage OPAMP is used to introduce the important concept of compensation.
The goal of compensation is to maintain stability with negative feedback is applied around the OPAMP.
The main aim of compensation is to provide stability with negative feedback.
The main aim of compensation is to provide stability with negative feedback is applied around the OPAMP.
Let's see a general block diagram of two-stage OPAMP.
The main blocks are a compensation circuitry, a differential transconductance stage, a high gain stage, an output buffer and a bias circuitry.
The main blocks are a compensation circuitry, a differential transconductance stage, a high gain stage, a output buffer and a bias circuitry.
The differential transconductance stage forms the input of the OPAMP and sometimes provides the differential to single-ended conversion.
A good portion of overall gain is provided by the differential input stage, which includes noise and offset performance.
The second stage is typically an inverter. If the differential input stage does not perform differential to single-ended conversion, then it is accomplished by second stage inverter.
The differential input stage does not perform differential to single-ended conversion, then it is accomplished by second stage inverter.
To drive a low resistance load, the second stage must be followed by a buffer stage.
To drive a low resistance load, the second stage must be followed by a buffer stage whose objective is to lower output resistance and maintain large signal strength.
Buffers are provided to establish proper operating point for each transistor in its quiescent state.
Compensation is required to achieve stable closed-loop performance.
Compensation of Op-Amp
Op-Amps are used in negative feedback configuration.
So, the relatively high inaccurate forward gain can be used with feedback to achieve very accurate transfer function.
FFS is a transfer function.
Loop gain is a product of amplifier gain and feedback factor.
For high loop gain, the forwarded transfer function Vout divided by Vin is accurately controlled by feedback network.
So, that's all about Compensation of Op-Amps.
Now, let's look at the small signal dynamics of a two-stage Op-Amp.
Yes, the signal is fed back to the input of the Op-Amp, be of such amplitude and phase that it does not continue to regenerate itself around the loop.
This result will either clamping of the output of the amplifier at one of the supply potential, the requirement for avoiding this situation is.
The signal is fed back to the input of the Op-Amp, be of such amplitude and phase that it does not continue to regenerate itself around the loop.
This result will either clamping of the output of the amplifier at one of the supply potential, the requirement for avoiding this situation is.
The signal is fed back to the input of the Op-Amp, be of such amplitude and phase that it does not continue to regenerate itself around the loop.
This result will either clamping of the output of the Op-Amp, be of such amplitude and phase that it does not continue to regenerate itself around the loop.
This is a small signal model for an uncompensated Op-Amp.

