Chế Tàu Turbo Hỗ Trợ Bơi - DIY Sea Scooter

Welcome to my channel Today I'm going to use these 6 turbo motors To make a swimming support device We use this to reflect water 3 7.4v 2s batteries These are T-shaped wires To connect these batteries Switch I use aluminum To make a body Remember to attach the glass Even if you put a lot of glue in it, it won't go in Attach all the screws I use these corners to make the bones harder Because when you attach glue, it is easy to break This side is hard enough Remember to attach the glass Now we will connect the switch I use 2 switches 2 6-speed Each switch has 3 motors When you need to run 3 motors at low speed Press and hold one side If you want to run fast, press both sides Remember to connect the glass To let the wind blow behind With this turbo Don't plug it in I made it slanted If we use 3, it won't be too close 1, 2, 3 Now we just need to plug it in These 6 wires are enough I use this wire To connect the 3 batteries To increase the capacity Use longer We just need to plug in this wire Connect to these 2 switches Now we have to drain these 2 switches I use rubber gloves I use 2 rubber gloves It's like lying down to swim Put it in front I am 70 kg I don't know if I can pull it I use aluminum to make it tight 2 parts In the afternoon, I made 1 part Now I make another part This one lost a lot of blood I use T-Bond glue Specialized in aluminum This cover must be glued Charge the battery 2S battery has these wires We just need to plug it in Very simple But the 2S battery We just need to plug it in Now I will wait for the battery to fill