How to Build DIY Cabinet Doors | Step by Step

How to Build DIY Cabinet Doors | Step by Step

H
Home improvement
147 Video Views·Feb 10, 2023

In this video, I will show you how to make cabinet doors with a table saw. If you are not familiar with woodwork, don't worry. I will guide you in detail on how to build cabinet doors.
My experiences in the video will help you have nice cabinet doors for your cabinets.

Steps to take
Step 1: Measure the height of the cabinet opening
Step 2: Cut to the exact door height
Step 3: Align the blade in the center of the board
Step 4: Run all four pieces through carefully holding each board tight
Step 5: Match the thickness of the plywood panel
Step 6: Check the fit with the plywood
Step 7: Add a scrap block of wood to the fence
Step 8: Make a three-eighths mark down from the end
Step 9: Line up the blade with the three-eighths mark
Step 10 : Advance the rail through the blade using the miter gauge
Step 11: Cut and nibble away the remaining amount of material
Step 12: Repeat the same milling process as before with a little effort
Step 13: Get the measurement for the quarter inch panel
Step 14: Set the door parts between two clamps and glue one side
Step 15: Slide the panel into place
Step 16: Measure from one corner to the opposite corner
Step 17: Set up a 35 millimeter Forstner bit in the drill press and drill 2 holes

HAND TOOLS:
Speed Square: https://amzn.to/31fv02z
End Cutting Pliers (they don't sell mine anymore): https://amzn.to/31hq1yt
Estwing Hammer: https://amzn.to/2VVnHMr
Chisel Set: https://amzn.to/2BjHH1H
Nail Set: https://amzn.to/2BdxCU4
Pry Bar Scraper (better then mine): https://amzn.to/2oGhKXu
Tape Measure: https://amzn.to/32gdEUt
15-Inch Utility Pry Bar: https://amzn.to/2IPlHQs
Level Set: https://amzn.to/33C56rD

POWER TOOLS:
Drills: https://amzn.to/2nDsqFV
Jigsaw: https://amzn.to/2AGpGua
Porter Cable Belt Sander: https://amzn.to/38D3kJe
Circular Saw: https://amzn.to/2Pvto2C
D-Handle Router: https://amzn.to/2ol4mYx
Small Router: https://amzn.to/2nEjDUe
Plunge Router: https://amzn.to/2LK29yQ

If you found the video helpful, please give us thumbs up and follow our channel for more tutorials: https://www.ganjing.com/channel/1fdircvfunm2rELZEFGjiDWWN1uf0c
Cre: @TrainingHandsAcademy (Youtube)