293. Trimming a Sodium Silicate Texture Moon Jar with Hsin-Chuen Lin 林新春 蓋罐修坯示範

Soul of Siberia
114 followers
56 Video Views·Aug 22, 2017
To see or buy my finished work and pottery tools, please visit my ETSY shop:
http://www.etsy.com/shop/hsinchuen
To watch more of my throwing videos, please visit my channel:
http://www.youtube.com/user/hsinchuen/videos
To learn more about my back ground, please visit my Website:
www.mypots.net
Okay, today I'm ready to trim my one jar that I made the other day.
before I trim I like to keep my tool sharp. So you can use a file or you can use a
grinder or whatever to get it sharp before you start the trimming. And then when you are trimming
you want to make sure that your hand is stabilized. Okay, you're finding the support so I usually have
my thumb here to hold it while I'm trimming it. So you see that I always keep my tool stay with
my left thumb as much as I can. If you want to go lower maybe your thumb won't be able to
to hold it. Then I will use my hand there to support it so my finger is resting right on
the corner of my trimming tool. So this will be my foot ring and then the clay in the middle.
This part is a little bit plain so I'm going to put some chattering texture on this portion here.
And I'm going to use my number one trimming tool to do that.
The trick for getting a nice chattering texture is that your clay shouldn't be too wet or too dry.
Too dry you won't be able to cut it deeper and too wet is going to be too deep. So make sure your
clay is at the hot stage and also when you are chattering using the tip of it. The tip should be
very sharp so you want to get a file to sharpen it especially the tip so you will cut it nice
and deeper. So that's the trick for cutting a nice chattering texture.
So this is the moon chatter. The foot is being trimmed.
I'm not turning upside down. I'm going to put a little bit of
decoration line here on this portion on the shoulder. I'm just using my number three trimming
tool so there's a little curve here.
So this is the trim. My moon jar. A bit of chattering texture here
and a lot of sodium silicate texture in the shoulder.
I'm ready to trim the lid. I told you that the lid is a little bit bigger so I will remove
a little bit clay. So I tried to fit it on the body and it's okay. So I'm going to go ahead and
trim the knob.
And again I'm using my number three trimming tool to undercut here so you have a nice curve.
chatter lid. Okay thanks for watching.
