Wasserspiel selber bauen

Florians Gartenwelt
51 followers
10 Video Views·Dec 11, 2022
We will build a small water feature here
Here a basin will be built from this natural stone
There's a water basin in there with a spring stone so there's some water splashing here by the terrace
So we have already excavated about 40 cm deep
There's a solid base underneath a sandy mixture nothing can go wrong
Now we are laying the gravel load-bearing layer
So that it works better we make the whole thing wet then it doesn't dust up so much
I have now poured a 10 cm thick layer of concrete over the compacted gravel base with reinforcement steel embedded in it
The stones are set in 20 cm concrete mixed with trass cement
This is important to avoid bleeding later
I have now filled the joint with mortar mixed myself
Three parts sand one part trass cement
To give the whole structure now some support and stability I have now built a formwork
We will now pour a concrete wall here so that the stones are reinforced once more and cannot collapse inward
when someone accidentally drives over it with the lawnmower or steps on it
So that's done for today I've already washed the stones
The concrete needs to set first then I can remove the formwork tomorrow
So 24 hours later the formwork has been removed
Now that you can see how we process the liquid membrane film I'll briefly go over the most important points to keep in mind
So that you can have a high-quality result
First the surface must be completely smooth with no holes cracks or pores allowed
After I removed the formwork here I filled everything again with putty to achieve this
Because the film only adheres to a completely smooth surface
Second point one must make sure that the surface is completely dry
In this case the concrete must be fully cured
There should be no remaining residue which I didn't quite manage here
I should have just waited another 4-5 days
Third point would be the weather
This is important insofar as it should be completely windless
because otherwise leaves insects pollen or anything else blown by the wind will
Stay stuck in the slide and then you can only get them out very hard
Make sure that there is no wind on the day of processing
The fourth point is that you must definitely check again no matter how clean everything is
It sucks up the floor the base the walls everything again with
an industrial vacuum so that even the last bit of dust disappears
Because you can tell immediately the film doesn't stick there you just can't process it
We have now applied three coats with the liquid membrane film
Also in the minimum you should do two but with three coats you're on the safe side
So now in civilian clothes because I'm done
One last thing I completely covered the pond liner
because I just found the color really ugly I could no longer live with it
Here I also built the raised bed using these porphyry large paving stones
This time two-tiered simply to catch the height and then to finish flush with the terrace
I also set a mowing edge using porphyry cobblestone 811 on the outside
with an irregular edge towards the lawn so that it looks a bit more relaxed
Various stone sizes which run through the entire garden here
This is by the way a solar pond pump I have the cable hidden a bit here
You can remove them from the water as needed in winter and then they go into the raised bed here
Here is the little house which I naturally have to hide and then the cable comes out down there
I've incorporated this into the joint I need to re-joint everything
Here I will also engrave it into the stone and then I will hang the solar cell here in front
So the planting is also done I have planted a few astilbes
Here is a clematis that will be attached to the terrace canopy here so it can climb
I planted wolf's milk epimedium and astrantia a few grasses
Here we have also dwarf's beard and a few ferns in the background
And this is what the whole thing looks like
So I hope you enjoyed the video
If you have any questions feel free to write I usually answer everything
