259. Using a Round Wooden Rib to Throw a Shallow Bowl with Hsin-Chuen Lin 林新春拉坯示範

Soul of Siberia
114 followers
5 Video Views·Dec 2, 2022
To see or buy my finished work or pottery tools, please visit my ETSY shop:
http://www.etsy.com/shop/hsinchuen
To watch more of my throwing videos, please visit my channel:
http://www.youtube.com/user/hsinchuen/videos
To learn more about my back ground, please visit my Website:
www.mypots.net
Okay, today I'm going to make a shallow bowl, so I'm using a piece of bash here, so after I finish I can pick it up.
Since I'm making a shallow bowl, my base will be wider, so when I'm centering, I don't want to squeeze up my clay.
I tend to center it down, push the clay down, so that my base will be wider, and from now I don't spread it out to the width I want it to.
Actually, I would like to have my width about this wide, but now my base is still this wide.
So I've got an initial opening here, using my thumb, and then I'm using my left hand too to help the thumb to open it deeper.
And you see that when I'm opening, my left thumb is still holding on the back, so I kind of compressed it to support it here.
Now I'm going to use my both hands to hold and drill the hole deeper, and then use both hands to grab the clay.
Like I told you, I would prefer to have my base a little bit wider, so I'm making a shallow bowl, the base needs to be wider to support it.
So now I'm going to push from the inside corner here, with my hand outside to support it, and spray the clay from the center.
When you try to spray the clay, I usually use my fingertips, and just by moving the tip slowly, you can spread out the clay easier.
So now the wall here is still a little bit thick, so I will lift it up. It's easier to open it up wider, so in the beginning I will try to lift up the wall, thin down the wall.
So basically I'm using my left thumb and fingers inside to lift the wall. My right hand is just there to stabilize it.
It basically is lifting from my left hand, since my thumb can still reach up from the base.
Just use the metal rib to lightly support it on the outside, and slowly stretch from the inside.
So the wall has been taken care of, and the inside here is still a little bit messy. It's not very flat, so I will try to spray the clay.
You see that this rib here has three holes, so I'm going to put my fingers in there to grab some water.
So I'm just going to tip over my rib here, so that I just use the center part, the flat side of the rib to compress the center point, and slowly move my rib outside.
Since I'm using the wooden rib, you can see that it's quite strong, so that your base is totally compressed.
The good thing about this rib is that even if you cross, you see that this is the center point, most of the ribs that have a very sharp edge, if you cross it over, your clay will get cut.
You could dig a line there, or a hole there.
But my design is that this rib has a curve here, you see that? Both curves on this side and this side.
So even if it crosses over the center point, it is still okay.
So that's the design of this kind of wooden rib.
You have the advantage of, even if you see that it crosses over the center point, it's still okay.
Press here, move the wooden rib slowly, and then the curve here, the curved side, you can go there and compress the wall.
Press it to the side.
Okay, so the base is fully compressed.
Now, there's a burr mark from the rib, so I'm just going to use the metal rib to smooth the surface.
So when I'm using the metal rib, I kind of go away from the center point.
Like I told you, if I cross over, this part will not be good.
To take care of the center point, actually, you can do this.
You smooth it first, and then you can just use the rib, maybe a quarter of an inch away from the center, so that the shallow bowl is done.
Now all I need to do is just smooth the rim.
Okay, so that's the bowl, the shallow bowl.
Of course, after you finish throwing, because the base is so wide, if you don't use a wire to wire it up, once the clay gets dry, it's very hard for you to cut it again.
So after you finish the shallow bowl, something that has a very wide base, you need to cut it off.
Use the wire to cut it off.
Let me show you.
I usually like to clean up my bed.
Okay, so to cut it off, you want to stretch your string.
Use both thumbs to hold it right against the bed.
And then, let me put my splash pan away so that it's not in the way.
So, put my thumb here.
The width of your thumb should be wider than the base.
Okay, so I'm going to hold my both thumb here on the edge of the bed.
And then, slightly spin the wheel.
It will help you to cut it.
So, slightly spin, and you can cut it easier.
Cut it flat, as long as you put your thumb right on the bed.
So, this is the finished one.
You can just pick it up, and you can put another one, and keep on throwing.
That's the good thing of using the bed.
Okay.
