As you learn how to build a birdhouse, you can work alone or with kids. Birdhouse design is a fun weekend project for the whole family. While you make your birdhouse plans, you may be inspired by cute ideas for birdhouses built to resemble a gingerbread cottage or a log cabin. This step-by-step guide teaches you how to build a DIY birdhouse using basic woodworking skills: https://thd.co/3TpO4az
The birds in your yard are looking for a safe place to nest, so a simple birdhouse design will meet their needs.
0:00 How to Build a Birdhouse 0:25 Step 1: Cut Your Wood 1:20 Step 2: Trim Front and Back Panels 2:17 Step 3: Drill Entrance 2:40 Step 4: Assemble Birdhouse 3:09 Step 5: Attach Roof 3:38 Step 6: Attach Perch 4:04 Step 7: Sand and Paint
About The Home Depot: How doers get more done. We’re helping doers in their home improvement projects. Now you can take on more renovation projects with more know-how. Our step-by-step instructional DIY videos and expert advice will give you the confidence for your next project with hands-on learning. It’s a good time to be a doer.
Hi, I'm Stephen Evans. We're at Peg Lake Studio and today we're building this cute little birdhouse
which is a fun project for the whole family. So let's get started. You will need just a few tools
for this project. We'll leave a full list of tools and materials at the end of the video.
We will build our birdhouse out of a single six foot one by twelve cut into seven pieces.
First up, cut a five by seven inch piece for the bottom of the birdhouse.
The walls are made from two five by five and a half inch pieces. For the front and back panels,
cut two seven and a quarter by eleven and a half inch pieces. You'll need two pieces for the roof.
One side will be nine and a half inches. The other side is eight and three quarter inches.
They both have a 31 degree cut on one end. Together they will create the roof's peak.
To make that angle cut, adjust the bevel gauge on your circular saw to 31 degrees.
Finally, cut the one and a half inch perch from a three-eighths inch wood dowel.
When it's all cut out, the front and back have five edges. Mark one and one-eighth inch from
each side of the bottom of the board. Mark five inches from the bottom up each side.
Find the center point of the top edge and mark it. Connect all of these points with lines.
Cut along the lines with a jigsaw or circle saw and do this on both panels. Time to create the
entrance. On one of the panels, measure five inches from the bottom and mark your entrance
spot. Make sure it's horizontally centered. Using a one and a half inch hole saw on your drill
for your birdhouse entrance. Okay, we are going to put this birdhouse together and you could use
a hammer and nails or I prefer to use a pneumatic nailer or powered nailer for assembly. Now we're
going to attach the roof. Run a thin line of wood glue along the front and back edges.
Place the roof pieces so the beveled edges create a point at the top of the roof.
Then nail the pieces together. To install the perch, mark a spot centered one inch beneath
the opening on the front panel. Use a three-eighths inch drill bit and drill a half inch deep hole.
Dab some wood glue, place it in the hole. Once the glue is dried, use an orbital sander to smooth
any rough edges. Now give your birdhouse some personality. Paint it, stain it, customize it
any way you'd like. I'm going to paint this green. It's a good idea to paint birdhouses green or brown
to help them hide from predators. When you are ready to build your own birdhouse, here's a full
list of the tools and materials you will need. Good luck and thanks for shopping at The Home Depot.