Treble Bleed

TheGospelGuitarist
1 follower
Apr 1, 2026
How to video on installing a treble bleed ciruit on the volume controls of electric guitars.
I'm going to install a treble bleed on the volume pots of an electric guitar.
I'm planning on doing it on all of my electrics.
First thing you need to do is go to Radio Shack and pick up a pack of 220 ohm resistors
if you have 500k volume controls. If you have 250k volume controls then you're going to want
to have a 150 ohm resistor instead of the 220s and even with these. These are all variables.
Everybody does some experimentation on these to find the values they like.
Also you're going to want to pick up some .001 or .002 capacitors. They come in different styles.
I'm using the ceramic discs here. Some people like to use the orange brand capacitors and
they're quite a bit bigger. These are just nice and small and they do the job I've used them before.
Okay what I did now was I just wired this up in parallel by taking the long connections on the cap
making a couple windings on each side of the resistor
and then what I would do is clip that extra wire off on this one.
You don't need it so just clip them off get them out of the way.
Then I'll coat these in solder here before I install it. Then just bend these down and
these are going to be the two connecting points. Typically on your guitar you're going to have
wires from your pickups connecting to the two open connections here. The other one will be
grounded to ground. On this particular one there's a steel wire. So you would take your
new assembly here and you would solder it across these two just like that. That way the high
signals will bypass the pot through the capacitor. Now you don't have to do this with a resistor.
However if you do use a resistor it will smoothen out the taper of the pot itself. Now some people
like that some people don't. So if you don't like the way your pot behaves after you do it with a
resistor just take it off and put a capacitor across these by itself. Another thing that you
can do is this as I said earlier was a parallel wiring. Well you can also do a series wiring
in which case some people do prefer you would attach a resistor to one end so it's actually
going to go the signal is going to go in one end and out the other and it's not going to travel
through them both in a parallel fashion like this. Now I have never used this this method
the serial method myself. I've been quite happy with the parallel but feel free to try whatever
you want. You've also got different values of both of these that can be used. Well here's a completed
group of four. Notice how I trimmed off the long extensions to make them a little bit shorter.
Usually when I do this trick I make quite a few of them and if I have extras I just give
them to friends. I hope that should do it. Okay as you can see here I've installed two circuits
because I have two volume controls. Well that's it for this video experiment with the parts and
resistor value and cap values and this is the one of the most popular setups right here with a
001 with a 220 resistor on a 500k pot. You may elect not to put one on your treble pickup
because it's already pretty bright anyway. I just did this for the video and for experimentation
so I hope you invite and enjoyed the video and have fun experimenting.
