Tiny Car Audio Amp Tested! Taramps DS160x2 Amp Dyno

Barely a Dent
19 followers
12 Video Views·Oct 20, 2022
What's going on guys? Derek here from Wilson Audio Labs. Today we're going to look at,
if not the smallest, one of the smallest amplifiers I've ever seen and definitely
the smallest one I've ever tested. This is a Taramp's DS160X2. Let's look up and see what's
in the box. You see we've got a couple of pieces of paperwork. We've got a high level input adapter
and yeah check the size out. So literally palm sized. Has speaker level inputs on one side. It
does not have RCA's. On the other you have your 12 volt power and ground connection as well as
your speaker outputs. It is a stereo amplifier. As far as dimensions go I told you it's small.
Three inches by 2.3 inches. Crazy small. By just a little over one inch in depth. Crazy crazy.
Class D. Rated 45 watts per channel at 4 ohms. 80 watts per channel at 2 ohms. And yeah we just had
to get one of these in and try it out. So here we are hooking it up. You can see we had to use some
small 12 gauge wire for the power and ground. We used 16 gauge for the speaker connections.
Got it wired up here on the bench and hooked in the speaker level inputs from the Pioneer 80PRS
head unit so that we could power it up. All right you can see the amp has no LED light. We're going
to turn on the head unit and it actually doesn't come on until it senses music. So let me start
the track. All right not much to it but to do it let's fire up the good old SMD Demore Engineering
Amp Dyno. Try this little palm size amplifier out to see how it performs. 4 ohms rated 45 watts by
2 at 13.8 volts. We're running the test at one kilohertz and we got 39 and 38 watts. So it's
close just not quite there. So let's try it uncertified. This takes us up to the clipping
point. Can we get that 45 watts? Not quite. A few watts shy. 40 and 38 at 14.38. And what about the
dynamic burst? Can we get the 45 watts per channel here? No we're still a little bit shy. 41 and 39
watts right at 14.42. I was a little bummed when I calculated efficiency. We only got 68 and a half
percent efficiency at 4 ohms. It should do much better than that. So that is a bummer. 2 ohms is
rated 80 watts by 2 in a palm size amplifier. So let's find out if it can do it certified.
Here we go. Fire it up. One kilohertz test track. Not there.
All right so not only did it fall short it fell way short.
Let's try uncertified. See what we get. 46 and 47 watts. Why are you rated 80 watts by 2?
I could never understand that. Maybe she's got it in her dynamically. Let's try dynamic. One kilohertz
and still shy. 68 and 61 watts. Got it. Got it. Yeah that's quite a bummer and with speaker level
inputs unfortunately you just can't get as clean of a signal as you could through RCA.
You can pause this if you want to see all the results. Here is a full test.
All the different results. Now next up we're going to try it out with some speakers and see if it
bumped.
All right just to show you don't have any funny stuff going on. Here's the Taramps 160x2. Here is
the head unit the Pioneer 80PRS. We have high level. We have speaker outputs going into the
inputs here of the Taramps. We have 12 gauge power going into this distro block down here
which goes to 8 gauge which goes to the 14 volt batteries and then we have the outputs which are
here. These are 16 gauge. You can follow them along. They're going right here into the dyno
and what we've done is we're just kind of using it as a bridge. Here are the wires. You can follow
them and they're going right in to the Blaupunkt 12. So we're going to try these four 12s out with
this tiny amp and see how it performs. You might be amazed. All right here we go. Let's fire it up.
Fill the vase part four. Due to copyright concerns I could not play very much of that song. Here's
the exterior measurement. 113 degrees Fahrenheit is about what we got. So now let's find out what's
inside this little mighty mite of an amplifier using our favorite screwdriver kit. Check the
video description. You can pick up one of these off Amazon and get one of these and help you out
just the way it helps me out every time I need to get into an app. Three screws on the bottom of this
amplifier. Then you can pull the little bottom plate off and see the bottom of the circuit board.
Let's pull it out and take a closer look. It's really difficult to portray size here. You can
just tell it's in the palm of my hand how small it is and these caps 470 microfarad 25 volt. They're
just so small and this one 25 volt 47 microfarad is literally the here's the size of a dime here
to give you an idea of how tiny these components are. Now it uses the 18 537 n which is a
n-channel x-fit power mosfet. It's really a class d amplifier built on this little tiny chip
which is really amazing. Now let's talk about the good things we like about this amp. The size you
cannot get over that how small it is. You can make a backpack stereo system if you wanted to.
Price is reasonable around 53 bucks. Sound quality is not bad. It does have the auto turn on when you
use the speaker connections and has insert terminals for all the leads which are nice.
Things that could be better. No RCA inputs. It has a fixed gain. It's lacking power at two ohms.
The efficiency is not great as you saw less than 70 percent at four ohms and reliability. We're
not sure with it being this small and putting out that much power make you think that it would
probably have some overheating issues if you're not careful. All right guys there you have my
test of the Taramps DS160 X2. I was really blown away with how it sounded with the speakers with
the bookshelf speakers and also the fact that it could push the subwoofer the way that it could.
Kind of really surprised me with that but it's too bad it didn't do its power at two ohms.
Still had fun. It's a tiny amp. If you need a really small amplifier take a look at this one.
Thanks as always for watching. It's Big D until next time. You know where I'm at. I'm out of here.
All right this is the Pioneer 80PRS. We're going to try certified four ohms.
Both channels measured. Here we go. 18 watts per channel. A little bit more.
20 and 19. All right let's try dynamic burst. Start right at 20 watts per channel. All right
Pioneer 80PRS. We're going to try dynamic two ohms 40 hertz burst track. There we go. 33 watts
per channel. All right so we know it did dynamic. Let's see if it can do certified at two ohms.
40 hertz two ohms. Here we go. Oh yeah. 30 watts per channel. Cool. Might as well do uncertified
while we're here. 80PRS internal amp. Two ohms. All right 32 watts. Cool.
