Sundown Audio SALT 3 Amp Dyno Test 3000W [4K]

Barely a Dent
19 followers
3 Video Views·Oct 20, 2022
Sundown Audio and SALT series. What does SALT stands for? Sundown Audio Low Voltage Technology.
Today we're going to look at the SALT 3. We've shown the SALT 2 before. Check the link in the
video description. You can see other tests of these amplifiers. This one retails for right
around $1,100. Your prices may vary based on when you watch this video. That's kind of expensive
for a 3,000 watt amp, but you know these are built like tanks and you can tell how well they're built
when I show the internals and yeah they're just you know sometimes you have to pay a little more
to get the nicer stuff. So I'm unboxing the SALT 2 here which I've shown before because all the
SALT 2, 3, and 4 amplifiers are pretty much the same excluding the length and the power output of
course. You can see here it comes with extra hex screws as well as a cable. Here's the bass knob.
This uses the RJ45 style connection. Remote and here's the bass remote. It gives you a voltage
and temperature in Fahrenheit. It is plastic. We'll talk about that later. It does come with a
small screwdriver so you can fine tune that voltage just to make sure it matches exactly
to your system. Now as far as specs go, the biggest things to note here 1 ohm stable,
24 dB per octave, low pass filter, and subsonic. As far as the specs go 750 at 4 ohms, 1500 at 2
ohms, 3000 at 1 ohm. These amps are linkable so you can hook up multiples and get double the power.
That's always interesting and they're very heavy duty. When you pick it up you can tell.
On one end of the amp we have Tiffany style RCA inputs and outputs, power protect, clip lights,
status indicator for those LEDs we talked about before. We have a gain from 0.2 to 6 volts,
subsonic 10 hertz to 50 hertz, bass boost 0 to 9 dB, remote indicator there that's where you plug
in for your bass knob, low pass filter, and phase adjustment as well as the linkable settings at the
end for master and slave. On the opposite end we have 1 ohm for power and ground. Again the salt
2, 3, and 4 look pretty much identical on this end. You have dual speaker terminal outputs,
however this is a monoblock amplifier for only a subwoofer application. On the amp this 4 pin
connection for status, what this is it gives you the ability using the wire included with the
little plug on it is to do remote status connection for power or protect. So if you want to extend
some LEDs you can do that. As far as dimensions go for the salt 3, 19.7 inches on the long side,
and for the width and the height 8.75 inches here for the width and 2.75 for the height. That's the
same across the line for these salt monoblocks. Now we'll get this wired up using our nice RCA's,
using the dual inputs, make sure we have enough juice, and we fire it up. Now let's talk about
the default settings of the amp because that people ask us all the time. First off the gain
is matched to the head unit with 7 dB of overlap, the subsonic is set to minimum, the low pass filter
is set to maximum or the highest setting, bass boost is set to minimum or zero, phase is set to
zero, and the master and slave of course is set to the master mode. Now let's fire up the good old
dyno to do our RMS power output testing of this amplifier. Before we do that make sure
you check the video description for links to Wilson Audio merch, smash me a thumbs up,
and subscribe if you like this content. More like it coming all the time. Now let's talk about the
dyno tests. There's three different tests, certified, uncertified, and dynamic. Certified
test takes us up to one percent THD, uncertified takes us up to the clipping point, and dynamic
is a dynamic tone mimicking IHF 202 standard. First up let's try four ohms. Amp is rated 750
watts at 14.4. Please note that I do have my new lithium bank going here so my voltage may be a
little high so you have to get over it. Rated 750 we got 1209, I'm sorry 1272 right at 15 volts.
Again these amps are beefy and you're definitely going to get more than the rated power.
Uncertified up to clipping at 40 hertz. You can see it just keeps going.
Geez is it ever going to stop. 1778 at 14.72. Now let's try the dynamic burst mode. This is a 40
hertz pulse track. Feeds into the amplifier. Again my voltage is a little bit higher than 14.4
but that is due to the new lithium bank. I'll try not to say that again. 1883 four ohms 14.74.
Efficiency wise we get about 95 percent efficient. So very nice. Next up let's try two ohms. Amp is
rated 1500 watts at 14.4. Here we go. Certified test of one percent THD. Easily beats that number
almost a hundred a thousand watts. 2475 at 15 volts. Uncertified to the clipping point.
It just keeps going. Look at this. Over 3000. 3136 at 14.44. So it does more at two ohms
than it's rated to do at one ohm. So again these amps are just beastly. Dynamic at two ohms. We got
3298. Almost 3300 watts when it's rated 1500. So over double. And efficiency still really good.
82.5 percent at two ohms. Now one ohm the amp is rated 3000 watts at 14.4. Based on what we've
seen before we expect it to blow that out of the water. And of course we do. 4184 watts at 14.15.
Just a beast. Again these amps are expensive but you're definitely getting more than the ratings
tell you. Also some durability built in there with the Korean quality. 4612 watts. One ohm at 13.98
to the uncertified mode. Now what about dynamic? Send that 40 hertz pulse tone in. Simulating like
music since it's so dynamic. Look at this. Over 5000 watts. One ohm. 14.21 volts. That's awesome.
Now as far as efficiency we're still really good. 83 percent at one ohm. As for the results yes we'll
say rated plus and actually rated way plus here if we see four ohms two ohms and one ohm. And I also
did eight ohm tests and I pretty much got almost the four ohm numbers at eight ohms. This amp is
just a beast. Now let's check the internals. See what's inside. Again Korean half bridge goodness
is what these amps have. And you can see here I got the salt 3 and the salt 4 from down for
sound at the same time. So I actually kind of ran the test together but I want to keep the salt 4
for a separate video because it's just worth it. I mean to show all the different tests and that
way you guys don't have to get confused as to what amp is being tested for what video.
Here you can see 35 volt 1200 microfarad for the input filtering and then 160 volt 1500 microfarad
for the output. The good stuff. It has a massive heat sink. It barely got warm during testing.
Rated power plus a whole lot more. Tiffany style RCA's which we love. These amps are linkable. If
you've got the juice then link them up. 24 db per octave crossovers. The remote bass knob has voltage
and temperature. Very good. We like that. Things that could be better. Of course it's a big amp.
Korean half bridge has a logarithmic pot on the bass knob so it turns up slowly and in the end
it turns up really fast. It's plastic bass knob. We kind of wish it would be a metal bass knob
especially at this price. The black lettering is hard to see on the amp so you have to use a light.
Korean equals big dollars and I would not use this amp at half an ohm. All right guys there you have
the test of the Sundown Salt 3. Again I'm going to have other salt amps. You can check the link
in the video description that I've tested and will test in the future. Thanks as always for watching.
Remember this is not a budget amplifier friends. This is your Denali or this is your King Ranch
or your TRD Pro if you want to use those similarities there. But yeah this is a great
amp overall. Thanks as always for watching. Until next time. Big D you know where I'm at.
I'm out of here. Yo yo let's throw some extras for the OG's who stick around till after the
credits. Always throw you some extras. Let's try 0.8 certified and here you go.
4814 watts at 14.05 volts. Uncertified up to clipping at 0.8. Can we get 5k? Yes we can. 5170
13.97. Dynamic. Check this out. We're closing in on 6k. 5785. Oh it jumped up. 5803 at 14.2.
Here is the overall chart of all the tests.
Thanks again guys for watching. More fun tests coming soon. Big D out.
